27 September 2012 in IEEE Transactions on Consumer Electronics
A new wireless charger, named as Human-Powered Wireless Charger (HPWC), is proposed for low-power mobile electronic devices in this paper. Unlike conventional plug and socket charger, HPWC is not only a wireless one but also powered by human. It can harvest human energy, convert it into electricity, and then deliver to mobile electronics wirelessly. Theoretical analysis on the working principle of the HPWC has been performed. In addition, conceptual experiments have been carried out to demonstrate the feasibility of HPWC. The output characteristics of HPWC with two kinds of receiver coils have been tested when it works at different frequencies. It is shown that the maximum open-circuit voltage of this charger can reach 1280mV, when the number of coil turns in receiver is 700 and the rotation frequency of hand crank is 1.5Hz. Moreover, the output voltage of HPWC with a load has also been measured. The maximum output voltage of HPWC with a load of 75Ω approximates to 400mV and an effective power of 1.1mW is gained when the 700 turns coil in receiver is available and the rotation frequency of hand crank is 1.5Hz. These results suggest the important value of HPWC in future electronics. Further, improvement and extensive applications of HPWC have also been discussed.
10 November 2021 in IEEE Intelligent Transportation Systems Magazine
18 May 2023 in Transportation Research Record: Journal of the Transportation Research Board
The fundamental diagram (FD) describes the functional relationship among macro parameters of traffic flow (e.g., volume, density, and space mean speed). A well-established FD is crucial for traffic operations and management (e.g., traffic estimation and control). However, there is still lacking an efficient method to select a FD and evaluate the fitting performance with empirical data. In this paper, we propose a novel evaluation approach to the FD using a linear transformation method, which can evaluate the fitting performance in the whole density region. It can also provide directions for further optimization of the FD model by performing the same transformation on the empirical dataset and the selected FD. Furthermore, we propose a quantitative indicator, called the weighted coefficient of determination, which can better evaluate the fitting performance of different FDs. The proposed method is tested with freeway field data from loop detectors. The results show that the proposed evaluation method can help select the FD that fits the empirical dataset best. The evaluation results can also be used to analyze the systematic deviation ignored by those FDs that cannot fit the data well to further improve FD models.
26 May 2025 in IEEE Transactions on Intelligent Transportation Systems
We consider the role of non-localities in speed-density data used to fit fundamental diagrams from vehicle trajectories. We demonstrate that the use of anticipated densities results in a clear classification of speed-density data into stationary and non-stationary points, namely, acceleration and deceleration regimes and their separating boundary. The separating boundary represents a locus of stationary traffic states, i.e., the fundamental diagram. To fit fundamental diagrams, we develop an enhanced cross entropy minimization method that honors equilibrium traffic physics. We illustrate the effectiveness of our proposed approach by comparing it with the traditional approach that uses local speed-density states and least squares estimation. Our experiments show that the separating boundary in our approach is invariant to varying trajectory samples within the same spatio-temporal region, providing further evidence that the separating boundary is indeed a locus of stationary traffic states.