1 January 2020 in Advanced Powder Technology
28 February 2017 in Powder Metallurgy
Additive manufacturing processes such as selective laser melting and electron beam melting require small particle sizes. A widely used technique to produce suitable powders is close-coupled atomisation. To further decrease the achieved particle sizes, the annular geometry of the gas nozzle is changed to a convergent–divergent (CD) profile. This novel configuration is capable of operating stably at low pressures of 0.8 MPa and above. Beyond that, the unwanted effects of lick-back are avoided. Different nozzles with conventional and convergent–divergent annular geometry have been designed based on fluid-flow calculations. The aspiration pressure was measured to determine stable process windows. Powders from a CuSn alloy were produced using cold and hot gas atomisation to show the influence on the process stability, particle size and morphology. High-speed recordings are used to investigate the process conditions of the different nozzle configurations.
1 March 2021 in Advanced Materials Research
The requirements regarding the materials in use are steadily increasing in the AM market. As part of a GER-CAN research project (HiPTSLAM), the development of high-performance tool steels for AM is a promising topic regarding the acceptance of LPBF technology for functionally optimized die, forming and cutting tools. Therefore, a holistic development process to efficiently qualify new materials is introduced and its advantages are shown based on a case study with a maraging tool steel. The chemical composition of the steel was particularly developed for the use in the LPBF process to achieve beneficial performance properties. In the case study, effects of the LPBF parameters are evaluated on the material properties. Based on initial microstructure analysis, a promising set of parameters is used to build samples for heat treatment studies and mechanical characterization. By means of further investigations on the process interfaces, it will be possible to optimize the interaction of the whole LPBF process chain to increase the number of qualified materials with better performance properties.