Geographic routing has been considered as an efficient, simple, and scalable routing protocol for wireless sensor networks since it exploits pure location information instead of global topology information to route data packets. Geographic routing requires the sources nodes to be aware of the location of the sinks. How can source nodes get sinks locations with low overhead is a difficult issue in wireless sensor networks. In this paper, we propose a Sink Location Service for geographic routing in wireless Sensor Networks. In this scheme, a source node and a sink node send sink location announcement and query messages along two paths respectively by geographic routing. The node located on the crossing point of the two paths informs the source about the sink location. Then the source can send data packet to the sink by geographic routing. How to guarantee that these two paths have at least one crossing point in any irregular profile of sensor network is the challenge of this paper. Simulation results show that our protocol is significantly superior to other protocols in terms of energy consumption and control overhead.
14 March 2022 in IEEE Wireless Communications Letters
As an emerging technology for the Internet of Things (IoT) wireless connectivity, there have been a lot of research and standardization activities on Visible Light Communications (VLC) and Optical Wireless Communications (OWC) using Light Emitting Diode (LED) lights. In the meantime, the Internet Protocol version 6 (IPv6) over Low Power Wireless Personal Area Network (6LoWPAN) has been discussed to provide the IPv6-based IoT services in wireless networks. However, the study on IoT systems using 6LoWPAN over OWC networks has not been made so far. This letter proposes a new architectural model to effectively use 6LoWPAN between IoT gateway and IoT device in the OWC-based IoT networks. The proposed model is easy to implement and provides the performance enhancement in OWC-based IoT networks, compared to the general IPv6 model. From testbed experimentations, it is shown that the proposed model provides the delay gain up to 5% and the throughput gain up to 19.52%, compared to the conventional IPv6 transport model.