Benjamin Phua

Benjamin Phua

Auto-generated profile, based on publicly available information

Benjamin Phua

School of Photovoltaics and Renewable Energy Engineering, University of New South Wales, Sydney, NSW, Australia

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 June 2018 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
PHPei-Chieh Hsiao
Pei-Chieh Hsiao
NSNing Song
Ning Song
XWXi Wang
Xi Wang
XSXiaowei Shen
Xiaowei Shen
BPBenjamin Phua
Benjamin Phua
Alison LennonAlison Lennon
Alison Lennon
Application of 266-nm picosecond (ps) laser ablation and copper (Cu)-plated metallization to p-type selective emitter (SE) passivated emitter and rear cells (PERC) is reported in this paper. Use of a 266-nm ps laser resulted in similar laser-induced periodic surface structures as observed for 355-nm ps laser ablation of a silicon (Si) nitride antireflection coating (ARC) on random-textured Si solar cell surfaces. In addition, it is shown that 266-nm ps laser ablation results in the formation of amorphous Si with an underlying distorted crystalline Si layer at the laser-ablated surfaces. The successful alignment of laser-ablated openings to the heavily doped SE regions resulted in a comparable cell efficiency of Cu-plated SE PERC cells to screen-printed controls, with a maximum cell efficiency of 20.6% being achieved for the Cu-plated cells. The plated cell performance was limited by the recombination losses, and in particular nonideal recombination caused by the use of a shallow emitter, which had been optimized for screen-printed metallization. Engineering of an SE with a junction depth of 0.52 μm in the heavily doped regions resulted in a 0.3% absolute increase in pseudo fill factor and demonstrated the importance of displacing the p-n junction from the laser-ablated Si surface. Although 355-nm ps laser ablation has been demonstrated to result in strong busbar adhesion in previous reports of Cu-plated cells, significant variability in the busbar adhesion of the fully plated SE PERC cells resulted by 266-nm ps laser ablation. The predicted increased sensitivity of 266-nm laser ablation to the ARC thickness and the possibility that surface oxides were not uniformly removed across wafers before plating may have affected the uniformity of silicide formation and hence the adhesion of the plated busbars.

1 February 2020 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
XSXiaowei Shen
Xiaowei Shen
PHPei-Chieh Hsiao
Pei-Chieh Hsiao
BPBenjamin Phua
Benjamin Phua
ASAlex Stokes
Alex Stokes
VGVinicius R. Gonçales
Vinicius R. Gonçales
ALAlison Lennon
Alison Lennon

1 January 2019 in Solar Energy
Verified
Journal Article
Closed access
BPBenjamin Phua
Benjamin Phua
PHPei-Chieh Hsiao
Pei-Chieh Hsiao
XWXi Wang
Xi Wang
ALAlison Lennon
Alison Lennon

9 March 2022 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
XSXiaowei Shen
Xiaowei Shen
PHPei-Chieh Hsiao
Pei-Chieh Hsiao
ZWZhimeng Wang
Zhimeng Wang
BPBenjamin Phua
Benjamin Phua
SLSean Lim
Sean Lim
ALAlison Lennon
Alison Lennon