13 May 2019 in Rapid Prototyping Journal
Purpose: Custom-designed metal bellows require alternate ways to produce the die to shorten lead time. The purpose of this study is to explore the possibility of using Additive Manufactured (AM) polymer die as direct rapid tool (RT) for metal bellow hydroforming. Design/methodology/approach: Finite element analysis (FEA) was used to simulate bellow forming and to evaluate the compatibility of AM die. Fused deposition modelling (FDM) technique is used to fabricate die with Acrylonitrile Butadiene Styrene (ABS) material. To validate, the width of the metal bellow convolutions obtained from the FEA simulation is compared with convolution formed during the experiment. Findings: FDM-made die can be used for a short production run of bellow hydroforming. FEA simulation shows that stress developed in some regions of die is less and these regions have potential for material reduction. Use of RT for this particular application is limited by the die material, forming pressure, width, convolution span and material of bellow. This supports the importance of FEA validation of RT before fabrication to evaluate and redesign die for the successful outcome of the tool. Research limitations/implications: The given methodology may be followed to design a RT with minimum material consumption for bellow forming application. Whenever there is a change in bellow design or the die material, simulation has to be done to evaluate the capability of the die. As this study was focused on a short production run for manufacturing one or few bellows, the die life is not a significant factor. Originality/value: This paper demonstrates about rapid tooling for metal bellow manufacturing using FDM technique for low volume production. Further, FEA is used to identify low stress regions and redesign the die for material reduction before die manufacturing. AM die can be used for developing customized metal bellow for applications such as defense, aerospace, automobiles, etc.
14 July 2022 in Transactions of the Indian Institute of Metals
1 May 2024 in Journal of Manufacturing Processes
1 January 2020 in Materials Today: Proceedings
1 June 2024 in 3D Printing and Additive Manufacturing
Selective laser sintering (SLS) is a powder bed fusion additive manufacturing process that uses polymer powders to produce functional parts directly from digital 3D models. SLS supports small- to medium-batch fabrication of customized products for various end-use applications. These parts can be used as tooling to support conventional manufacturing and inspection where mechanical and tribological behaviors are important. This article evaluates the friction behavior of parts fabricated by SLS polyamide (PA12) and glass bead-filled polyamide (PA-GF) materials. Pin-on-Disk tribometer was used to characterize the behavior in dry sliding conditions with part build orientation, load, and speed as factors. Taguchi's approach and analysis of variance are used to quantify the influence of these factors on the friction coefficient. Both materials show reduction in friction coefficient with the increase in load; on the other hand, an increase in speed affects adversely. However, the influence of part orientation is comparatively lesser than the other two factors considered in this study. The debris, pin, and disk wear surfaces were examined to learn wear mechanisms. It is observed that surface porosity resulting from the fabrication process plays a significant role in friction behavior. The glass beads in PA-GF material function as reinforcement against load and influences the friction behavior. Low friction and wear characteristics make both materials as a prospective contender for tooling application.