1 January 2017 in Biomicrofluidics
Active manipulation of droplets is crucial in droplet microfluidics. However, droplet polydispersity decreases the accuracy of active manipulation. We develop a microfluidic “droplet filter” that accurately separates droplets by size. The droplet filter has a sharp size cutoff and is capable of distinguishing droplets differing in volume by 20%. A simple model explains the behavior of the droplets as they pass through the filter. We show application of the filter in improving dielectric sorting efficiency.
17 May 2023 in Nucleic Acids Research
Despite the need in various applications, accurate quantification of nucleic acids still remains a challenge. The widely-used qPCR has reduced accuracy at ultralow template concentration and is susceptible to nonspecific amplifications. The more recently developed dPCR is costly and cannot handle high-concentration samples. We combine the strengths of qPCR and dPCR by performing PCR in silicon-based microfluidic chips and demonstrate high quantification accuracy in a large concentration range. Importantly, at low template concentration, we observe on-site PCR (osPCR), where only certain sites of the channel show amplification. The sites have almost identical ct values, showing osPCR is a quasi-single molecule phenomenon. Using osPCR, we can measure both the ct values and the absolute concentration of templates in the same reaction. Additionally, osPCR enables identification of each template molecule, allowing removal of nonspecific amplification during quantification and greatly improving quantification accuracy. We develop sectioning algorithm that improves the signal amplitude and demonstrate improved detection of COVID in patient samples.
14 September 2025 in Critical Reviews in Biotechnology
Polymerase chain reaction (PCR) is a critical technology in nucleic acid detection and quantification. The PCR reaction requires thermal cycling the reaction mixture between two or more temperature stages for ∼30 cycles to achieve exponential amplification of the target DNA. Typically, the thermal cycling takes roughly an hour to finish and the large time consumption is a drawback for PCR. We review the various methods developed to reduce the thermal cycling time and build a rapid PCR. We group the methods to two approaches. The first approach is to increase the local heating/cooling power. The methods in this approach include contact heating, such as: heating resistors and Peltier pumps, and non-contact heating using air-blow, radiation on water and plasmonics. The other approach is to rapidly move the reaction mixture to a different temperature zone. Methods in this approach include: relocating the reaction vessel, continuous flow PCR using microfluidic chips, long tubes or oscillatory PCR scheme, and convective PCR. We analyze the advantages and challenges for each method used and the critical parameters to consider when evaluating the technologies. We review the technological advances and commercialization for each method. We also discuss the current challenges and future directions in building an effective and commercial rapid PCR, with the emphasis on sensitivity, portability and cost.