The objective of this article is to study experimentally optimizing of a PMSG wind turbine connected to a DC-DC converter (Boost) and a resistive load. For this, tests were conducted to determine the law of open loop control (power versus the duty cycle for different values of wind speed and load). The results showed that the power passes through a maximum point. In order to extract the maximum power, for different values of wind speeds and load, an MPPT control "Perturb and Observe" P & O has been implemented on a DSPACE 1104. The experimental results showed the performance of the method suggested.
1 February 2014 in Energy Conversion and Management
The objective of this research work is to provide a effective assistance to all those who have to make decisions concerning the planning and implementation of projects in the renewable energy. Indeed, The integration in the Moroccan power grid of electrical power via Concentrating Solar Power (CSP) units using parabolic mirrors or solar tower is expected to have a significant impact on the reliability of the electrical system. In this context. Therefore, in this work, firstly, we assess the reliability of the Moroccan grid at hierarchical level HL1 (HL1: load covering under the assumption of infinite node) by use of a non-sequential Monte Carlo simulation in which CSP units (with parabolic through mirrors and with Solar tower) are introduced. Secondly objective of this paper is to assess the reliability of the Moroccan grid with an expected common integration of 14% wind and 14% solar energy
1 September 2016 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Tracking the maximum power point plays an important role for the optimization of the solar energy. The objective here is to study experimentally optimizing photovoltaic (PV) systems connected to a DC-DC converter (Boost) and a resistive load. For this, tests were conducted to determine the law of open loop control (power versus the duty cycle) for different solar irradiance values and load with an approximately constant cell temperature. The obtained results showed that the power passes through a maximum point. In order to extract the maximum power, for different values of solar irradiance and load, an MPPT control "Perturb and Observe" P & O has been implemented on a DSPACE 1104. The experimental results showed the performance of the method suggested.
Many applications often require a power supply with a constant voltage, e.g: a 311V output from a wind alternative source varies from 240V to 340V. Faced to this requirement, the use of a DC-DC Buck/Boost converter associated with a rectifier is required. Several architectures of the Buck/Boost choppers have been proposed in the literature; among these architectures, we find the classic Buck/Boost and Buck+Boost in cascade. These ones have a low yield and can also reverse the sign over the entrance. In this article, we present the new Buck/Boost shunt non-inverted architecture with a higher yield than the other topologies. Moreover, we propose a switch command to switch the system between Buck and Boost function. Simulation results on Orcad Pspice show that the proposed system can provide a very good efficiency and excellent performance.