13 April 2018 in Wind Energy Science
Renewed interest in yaw control for wind turbine and power plants for wake redirection and load mitigation demands a clear understanding of the effects of running with skewed inflow. In this paper, we investigate the physics of yawed operations, building up the complexity from a simplified analytical treatment to more complex aeroelastic simulations. Results in terms of damage equivalent loads (DELs) and extreme loads under misaligned conditions of operation are compared to data collected from an instrumented, utility-scale wind turbine. The analysis shows that multiple factors are responsible for the DELs of the various components and that airfoil aerodynamics, elastic characteristics of the rotor, and turbulence intensities are the primary drivers. Both fatigue and extreme loads are observed to have relatively complex trends with yaw offsets, which can change depending on the wind-speed regime. Good agreement is found between predicted and measured trends for both fatigue and ultimate loads.
10 November 2014 in Wind Energy
3 March 2008 in Structural Health Monitoring
Structural Health Monitoring (SHM) of a wind turbine blade using a Structural Neural System (SNS) is described in this paper. Wind turbine blades are composite structures with complex geometry and sections that are built of different materials. The 3D structure, large size, anisotropic material properties, and the potential for damage to occur anywhere on the blade makes damage detection a significant challenge. A SNS based on acoustic emission (AE) monitoring (passive listening) was developed for practical low cost SHM of large composite structures such as wind turbine blades. The SNS was tested to detect damage initiation and propagation on a 9 m long wind turbine blade during a quasi-static proof test to failure at the National Renewable Energy Laboratory test facility in Golden, Colorado. Twelve piezoelectric sensors were bonded on the surface of the wind turbine blade and connected to form four continuous sensors which were used in the SNS to determine damage locations. Although 12 sensors monitored the wind turbine blade, the SNS produces only two analog output signals; one time signal to determine and locate damage, and a second time signal containing combined AE waveforms. Testing of the wind turbine blade produced some interesting results. After initial emissions due to settling of the blade diminished, damage initiated at one location on the blade. As the load was increased, damage occurred in a sequence at three other locations until there was a catastrophic buckling failure of the blade. The buckling occurred above the design load for the blade, and was due to the carbon spar cap disbonding from the fiberglass shear web under compressive bending stress. The SNS indicated the general area where the damage started and how the damage progressed, which is valuable information for verifying and improving the blade design and the manufacturing procedure. Strain gages on the blade did not provide a clear indication of damage until buckling occurred. A major outcome of this testing was to provide confidence that SHM of large composite structures that have complex geometry and multiple materials is practical using a simple, low cost SNS.