1 April 2016 in Engineering Structures
12 December 2022 in Journal of Sound and Vibration
7 August 2020 in IEEE Transactions on Vehicular Technology
The numerical model is a well-acknowledged tool to evaluate railway pantograph-catenary interaction performance. The current standard restricts most current simulation tools by a cut-off frequency of 20 Hz. This low-frequency range of interest cannot fully describe the current collection quality of pantograph-catenary. This paper includes simulation with cut-off frequencies up to 200 Hz to investigate the high-frequency behaviour of pantograph-catenary interaction. The reference model of pantograph-catenary in the benchmark is taken as the analysis object. Firstly, the effect of key simulation parameters of the resulting contact force is investigated. A small element length in the finite element model is proposed to prevent the frequency range of interest being contaminated by the numerical error. The contact stiffness has an opposite effect on the contact force in low and high-frequency ranges. Then the source and the amplification factor of high-frequency components of contact force are investigated. The results show that the half and quarter of the dropper/steady arm interval length presents the primary source of high-frequency components of the contact force. The corresponding wavelength can also be found in the high-order modes of the catenary. Finally, a variable time step procedure is also proposed to capture the contact loss occurring at high frequencies accurately. The comparison of the results between the variable and constant time steps indicates that the traditional constant time step may result in errors when calculating the contact loss duration.
22 April 2022 in Engineering Structures
15 September 2015 in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
An increasing demand for reduced travel times requires the exploitation of the full capacity of existing overhead railway catenary systems. This need has become an issue in Norway, as the majority of existing catenary systems are designed for a maximum speed of 130 km/h. In many regions, plans to reconstruct the railway line do not exist. Therefore, existing catenary sections must be optimized to increase a train’s velocity and reduce the total travel time. In this paper, the dynamic response is evaluated in an optimization investigation of an existing soft catenary system. A dynamic investigation that considers finite element models of existing soft railway catenary sections with original tension forces, current tension forces and suggested new tension forces for velocities at and above the design speed is conducted. The dynamic response is quantified by the interpretation of spectral densities and variations in their peak values. Due to more movement at mid-span than at the pole support, the effects from altering the tension forces and increasing the speed can be more accurately described and estimated by considering the dynamic content of the response at mid-span instead of the peak uplift at the pole support. A 23% increase in speed is possible for the system with the best tested new tension force setting, in which only the dynamic response and uplift at the pole support are considered.
20 February 2015 in Vehicle System Dynamics