30 May 2024 in INTERNATIONAL JOURNAL OF EXPERIMENTAL RESEARCH AND REVIEW
High-strength-to-weight ratio materials are crucial for the automotive and aerospace sectors, driving the demand for advanced solutions. Traditional monolithic materials fall short of meeting these requirements, prompting the exploration of ceramic-based metal matrix composites. Among these, the Al/B4C composite stands out for its exceptional wear-resistant properties, attributed to its heightened hardness and shear resistance. This study investigates the wear performance of AA 7050-7.5% B4C-T6 Composite, produced via flux (K2TiF6) assisted stir casting method. The wear rate serves as the primary performance metric, evaluated using a pin-on-disc tribometer. Experimental design employs a Taguchi L9 orthogonal array, facilitating systematic analysis. Taguchi Analysis optimizes the process parameters, revealing insights into their impact on wear performance. The wear rate directly correlates with both applied load and sliding distance, indicating higher wear with increased stress and sliding duration. Additionally, the sliding speed intermittently influences the wear rate due to a Mechanical Mix Layer (MML) presence, highlighting the complex interplay of factors influencing wear behaviour. In summary, this research underscores the potential of AA 7050-7.5% B4C-T6 Composite as a promising wear-resistant material, offering valuable insights into optimizing its performance through controlled process parameters.
6 October 2023 in Key Engineering Materials
The Al-B4C composites are exclusively applicable in the structural components of automobiles and aerospace. It is also termed a hard-to-cut material. Hence, the Machining of such materials with firm design and close tolerance is a key concern in the present era of the manufacturing world, particularly through the conventional machining process. The prime motive of this paper is to evaluate the Machinability performance in terms of MRR and SR of the AA7050-7.5% B4C-T6 Composite using die-sinking EDM. The Taguchi L9 DOE was employed for the execution of experiments to assess the machinability performance of the composite in terms of MRR and Ra, with the simultaneous effect of input parameters such as Ip, Ton, and sand parking voltage (Sv). Further, the parameters were optimized using the Taguchi Analysis. ANOVA analysis was performed to evaluate the significance and contribution of the input parameters toward performance measures.