1 August 2017 in Biosensors and Bioelectronics
5 January 2023 in IEEE Sensors Letters
PID controllers are widely used in different systems including Electric vehicles (EVs) for their simplicity and practical application. However, there are errors between the controlled signal and the desired signal. This system controls EV speed using a sensor feedback-supported novel controller based on a novel Dandelion Optimization PID controller (DO-PID). This article aims to reduce system error between the reference and output signals. The results obtained from the proposed controller are compared with classical PID control, Fire Fly-PID controller, Teaching Learning Based Optimization (TLBO)-PID controller, and Particle Swarm Optimization (PSO)-PID controller. Simulation results show that the novel controller outperforms the existing controllers. Various types of errors are found for all the controllers, and it is seen that the error obtained from DO-PID is less than the error from other controllers. It is found that the Integral Square Error (ISE), Integral Absolute Error (IAE), Integral Error (IE), Integral Time Square Error (ITSE), and Integral Time Absolute Error (ITAE) in controlling the speed of EV with DO-PID controller are obtained as 0.04161, 0.1115, 0.04022, 0.02068 and 0.02068 respectively. Finally, analysis has been done to check the disturbance rejection capability of the proposed controller.
1 January 2019 in Biosensors and Bioelectronics
2 August 2022 in Advanced Engineering Materials
1 January 2019 in Sensors and Actuators A: Physical
17 February 2016 in Nanoscale
Exposure of a volatile organic vapour could set in powerful rotational motion a microdroplet composed of an aqueous salt solution loaded with metal nanoparticles. The solutal Marangoni motion on the surface originating from the sharp difference in the surface tension of water and organic vapour stimulated the strong vortices inside the droplet. The vapour sources of methanol, ethanol, diethyl ether, toluene, and chloroform stimulated motions of different magnitudes could easily be correlated to the surface tension gradient on the drop surface. Interestingly, when the nanoparticle laden droplet of aqueous salt solution was connected to an external electric circuit through a pair of electrodes, an ∼85–95% reduction in the electrical resistance was observed across the spinning droplet. The extent of reduction in the resistance was found to have a correlation with the difference in the surface tension of the vapour source and the water droplet, which could be employed to distinguish the vapour sources. Remarkably, the power density of the same prototype was estimated to be around 7 μW cm−2, which indicated the potential of the phenomenon in converting surface energy into electrical in a non-destructive manner and under ambient conditions. Theoretical analysis uncovered that the difference in the ζ-potential near the electrodes was the major reason for the voltage generation. The prototype could also detect the repeated exposure and withdrawal of vapour sources, which helped in the development of a proof-of-concept detector to sense alcohol issuing out of the human breathing system.