Metal halide perovskites emerge as promising semiconductors for optoelectronic devices due to ease of fabrication, attractive photophysical properties, their low cost, highly tunable material properties, and high performance. High‐quality thin films of metal halide perovskites are the basis of most of these applications including solar cells, light‐emitting diodes, photodetectors, and electronic memristors. A typical fabrication method for perovskite thin films is the solution method, which has several limitations in device reproducibility, adverse environmental impact, and utilization of raw materials. Thermal evaporation holds great promise in addressing these bottlenecks in fabricating high‐quality halide perovskite thin films. It also has high compatibility with mass‐production platforms that are well‐established in industries. This review first introduces the basics of the thermal evaporation method with a particular focus on the critical parameters influencing the thin film deposition. The research progress of the fabrication of metal halide perovskite thin films is further summarized by different thermal evaporation approaches and their applications in solar cells and other optoelectronic devices. Finally, research challenges and future opportunities for both fundamental research and commercialization are discussed.
16 December 2025 in Journal of Materials Chemistry A
Recent research progress in low-toxicity light-absorbing materials for indoor photovoltaic applications is discussed, with a particular focus on emerging lead-free halide perovskites.
Tin-based halide perovskites (THPs) have emerged as promising lead-free light absorbers for indoor photovoltaics (IPVs). However, surface-defect-mediated recombination and Sn2+ oxidation remain major limitations, especially in vapor-based sequential deposition of perovskite films that requires solid-state conversion and careful control in stoichiometry. Herein, we address this challenge using a surface passivation strategy via thermal evaporation to modulate interfacial defects of tin-based perovskite thin films. We found that thermally evaporated 1,3-propanediammonium iodide (PDAI2) on the perovskite surface can significantly reduce Sn2+ oxidation and suppress the formation of surface halide-vacancies, which in turn reduces trap-assisted recombination, and improves the band alignment at the electron contact interface. Consequently, the best-performing devices based on the optimised films can achieve a power conversion efficiency (PCE) of 18.36% under 1000 lux indoor light illumination. Under AM 1.5G illumination, an open circuit voltage (Voc) of 0.85 V is also obtained, which is higher than that of the previous reports using thermally evaporated THP. This work highlights the importance of surface defect passivation for improving the device performance and provides insight into a scalable pathway for lead-free perovskites in efficient IPV applications.