Xylitol is a low calorie sweetener that can be produced through a bioconversion approach from lignocellulosic biomass that requires pre-treatment prior to the bioconversion of xylose to xylitol. Steam explosion (SE) is an industrially scalable pre-treatment (PT) process with the potential to liberate xylose monomers, however SE-PT has not been optimized for xylose release from multiple feedstock. The effect of pressure, substrate weight, phosphoric acid loading concentration and residence time on four feedstock [wheat straw (WS), corn stover (CS), Miscanthus (M), and willow (W)] for xylose release and minimal fermentation inhibitor production [furfural and 5-hydroxymethylfurfural (HMF)] was investigated using the Taguchi methodology for design of experiment (DoE) with variation at four levels (44). An L16 orthogonal array design was utilized and all factors indicated influence on xylose release and inhibitor formation and the resulting xylose rich hydrolysate assessed for bioconversion to xylitol. The L16 DoE gave hydrolysates containing 75–95% of xylose content in the original biomass, whilst retaining cellulose and lignin components in the fiber. The level of inhibitors were within boundary limits to enable microbial fermentation of the hydrolysates to xylitol. Fine tuning of the overall evaluation criteria (OEC) model imbibing 1.5 kg feedstock in 1.2% w/v orthophosphoric acid, 12 bar(g) and 6 min residence time resulted in 90% xylose recovery and production of >1,000 L of wheat straw hydrolysate for bioconversion to xylitol. The advantages and limitations of the Taguchi OEC model and further improvements to this process are discussed in a biorefining context.
Efficient utilization of lignocellulosic biomass requires pretreatment in order to liberate cellulose from lignin and disrupt its recalcitrant crystalline structure before effective enzymatic hydrolysis can take place. Three different pretreatment methods (pressure cooking with dilute alkali and dilute acid as well as alkaline extraction) to recover the xylooligosaccharides fraction from five different grass silage samples, whole crop rye silage and maize silage were compared. The predominant end products released were xylobiose, xylotetraose, xylopentaose and xylohexaose whereas the xylooligosaccharides release pattern differed with the substrate. Maximum values of xylooligosaccharides was found for grass silage 17.26 g/L, whole crop rye silage 3.06 g/L and for maize silage 5.77 g/L. Results reveal the production of high value by-products from agricultural biomass. Advantages of the green-biorefinery concept include a resulting liquid fraction after pretreatment with very low contents of inhibitors such as furfural, hydroxymethylfurfural (HMF) and phenolic compounds.
The Miscanthus genus of perennial grasses is grown for bioenergy and biorenewable feedstocks. Most Miscanthus crop is M × giganteus which is rhizome propagated and therefore difficult to multiply at large scale. Seed-based propagation of new hybrids is being developed, but Miscanthus is difficult to establish from seed especially in the field. Miscanthus is often grown on marginal land adding to the challenge of successfully establishing the crop. Improved understanding of the limits and biology of germination in Miscanthus species is needed. Seed germination is affected by physical and chemical factors that impact germination differently depending on level of exposure. In this investigation of Miscanthus germination, four hormones plus water stress were investigated and the range over which these factors affect germination was determined. An efficient Taguchi experimental design was used to assess the five factors in combination with the effects of light and seed priming. This determined an example of a set of optimum conditions for Miscanthus germination and demonstrated how this could change based on fixing one condition. The experiment showed how environmental stress impacted germination and how treatments such as gibberellic acid could be used to mitigate stress.