30 September 2022 in IEEE Transactions on Antennas and Propagation
In this paper, a dual-band shared-aperture reflectarray (RA) with a phased array is proposed for inter-satellite links. The Ka-band reflectarray is integrated with an X-band phased array by a sharing mushroom patch structure. The high-frequency ratio allows the high-frequency reflectarray and the low-frequency broadband phased array to operate independently to support high-speed communication of the geostationary orbit (GEO) relay nodes in the inter-satellite network. To verify this concept, a prototype of the antenna is designed and fabricated, and its electrical performance is measured. The reflectarray presents a peak gain of 30.1 dBi (28 GHz) and a 3 dB gain bandwidth of 11.4% (26.4 to 29.6 GHz). The phased array presents the peak gain of 21.7dBi (9 GHz), and the relative bandwidth can reach 45.3% in the boresight direction. The scanning range can cover ± 45°, and the H/E planes scan gain losses are less than 2.34 dB and 4.33 dB, respectively.
2 November 2023 in IEEE Transactions on Antennas and Propagation
This communication proposes a reconfigurable reflectarray (RA) with decoupled RHCP/LHCP 2D beam steering. A simple-structured unit with mechanical reconfigurability is designed to achieve the 1×1-bit dual-circularly-polarized (dual-CP) phase modulation, which enables the decoupled 2D scanning of the dual-CP beams. A prototype of the designed reconfigurable dual-CP RA is tested under two working scenarios. For the RHCP beam at (45°, -30°) and the LHCP beam in (135°, 0°~-50°), the RHCP/LHCP gain fluctuation is less than 0.9/2.9 dB. For the LHCP beam at (135°, -30°) and the RHCP beam in (45°, 0°~-50°), the RHCP/LHCP gain fluctuation is less than 3.0/0.7 dB. For the RHCP and LHCP beams at (45°, -30°) and (135°, -30°), the axial ratio (AR) bandwidth is over 24% (AR < 2 dB), and the overlapped 1-dB gain and AR < 2 dB bandwidth is 7.5%. The prototype also exhibits ideal AR beam width of over 6° (AR < 2.5 dB) and maximum aperture efficiency of 20.9%. The proposed reflectarray design simultaneously realizes independent polarization control and dual-CP 2D beam steering for the first time, which is of great value in many fields.
1 January 2024 in IEEE Access
The employment of Massive MIMO technology in 5G communication results in a large number of RF channels in the base station. Therefore, the base station will suffer from the huge burden of equipping discrete bandpass filters under the traditional filtering strategy. An alternative filtering strategy called spatial filtering characterizes direct covering frequency selective surface (FSS) on multi-channel antenna array of base station and is expected to greatly relax the need for discrete bandpass filters. An aperture-coupled-cross-resonator (ACCR) FSS based spatial filtering scheme is investigated in this study. A low-profile spatial filtering patch array (LPSFPA) with thickness of $0.07\lambda _{0}$ and operating around 3.6GHz is constructed by placing an asymmetrical ACCR FSS tightly upon a patch antenna array with a half-period lateral shift. A good out-of-band suppression at both band-edges and enhanced in-band impedance bandwidth are achieved when the main beam is scanned with an elevation angle range of 0° to 30° and arbitrary azimuth angle. To verify the design, a finite LPSFPA sample whose main beam can be directed to $\theta _{\mathrm {b}}= 0^{\mathrm {\circ }}$ , $15^{\mathrm {\circ }}$ and $30^{\mathrm {\circ }}$ in E plane by different phasing and power-dividing networks is fabricated and tested. The measured results show that the fabricated LPSFPA sample is superior to the ordinary radiation patch array without the ACCR FSS in terms of both the impedance bandwidth and out-of-band suppression for various main beam directions. For the normal-beam case, the measured −10dB impedance bandwidth is from 3.6-3.8 GHz; the measured out-of-band suppression level of peak realized gain is more than 19 dB in the lower band-edge from 3.2-3.5 GHz and 17 dB in the upper band-edge from 3.9-4.2 GHz. The proposed spatial filtering scheme has no negative influence on the radiation performance of the radiation patch array.
7 July 2022 in IEEE Transactions on Antennas and Propagation
Space selectable microwave heating is a new trend of customized heating at present and in the future. Controllable antenna array (CAA) can effectively achieve space selectable heating, which has drawn wide attention. In this article, a novel CAA approach of frequency multiplexing patch antenna array (FMPA) is proposed, with which the constituted patch elements have totally different resonant frequencies and each patch element exclusively takes charge of the heating task for certain sub-area of entire planar area under heating. An all-metal four-element FMPA is designed as an example. It is integrated with a metal chamber where the target heating area is enclosed. Simulation results verify that the proposed FMPA has the function of independent space-selectable heating. Then, a controllable microwave heating system is built for the subsequent heating experiment. The experiment shows that, after the corresponding patch element being activated, the coverage ratio of each target heating sub-area is more than 90%, and the error ratio less than 1.5%. The proposed CAA technique of the FMPA enjoys vast potential in customized heating applications that has higher requirements for resolution of the sub-areas under heating. Its advantages include low cost, low loss, and high space utilization rate.