Michael O'ROurke

Michael O'ROurke

Auto-generated profile, based on publicly available information

Michael O'ROurke

Department of Civil and Environmental Engineering, Rensselaer Polytechnic Institute, 110 8th Street, Troy N.Y. 12180-3590

Research Focus & Metrics

Academic Career Length

26Years (2001-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2005 in Earthquake Engineering and Engineering Vibration
Verified
Journal Article
Closed access
PDF file
MOMichael O'Rourke
Michael O'Rourke
VGVikram Gadicherla
Vikram Gadicherla
TATarek Abdoun
Tarek Abdoun

1 April 2005 in Journal of Structural Engineering
Verified
Journal Article
Closed access
MOMichael O’rOurke
Michael O’rOurke
ADArthur DeGaetano
Arthur DeGaetano
JTJanine Derjue Tokarczyk
Janine Derjue Tokarczyk
An analytical procedure for simulating roof snow drift loads is presented. The procedure is based upon the physics of drift formation and consists of two elements. The first element is the transport rate which quantifies the snow flux from the snow source area. The second element is the trapping efficiency which quantifies the percentage of transported snow from the source area which is captured at the drift. Knowing wind speed and snowfall information for a given winter, the procedure can be used to simulate the annual maximum drift for a given snow source area. The method is applied to over 40 years of weather data at each of over 50 NWS first-order sites across the United States. The calculated annual maxima are fit with an extreme value distribution to determine 50-year drift loads for both roof step and gable roof geometries. It is shown that current leeward roof step drift provisions in ASCE 7-02 as well as gable roof drift provisions proposed for ASCE 7-05 yield loads with something close to a 50 y...

24 June 2009
Verified
Conference Paper
Closed access
MOMichael O'ROurke
Michael O'ROurke
An analytical fragility relation for seismic damage to segmented pipe is presented. The relation is based upon a simplified mechanistic model with rigid pipe segments and flexible joints, subject to ground strain parallel to the pipeline longitudinal axis. As such it is applicable to both wave propagation and PGD hazards. In the model, ground strain is accommodated by opening of the pipeline joints. That is, the current model considers tensile ground strain only. The results for small diameter cast iron pipe subject to tensile ground strain match the empirical observation (repairs per kilometer) quite well for roughly an order of magnitude of ground strain. It is felt that the current model provides a good starting point for analytical models applicable to other diameters and pipe material as well as all levels of both tensile and compressive seismic ground strains.

24 June 2009
Verified
Conference Paper
Closed access
MOMichael O'ROurke
Michael O'ROurke
Some mistakenly believe that wave propagation damage to continuous buried pipe does not occur. Although not common, there have been situations in the past where it has occurred. Two such case histories are presented in the paper with the intension of clarifying the issue. The first case history is local buckling damage to 42 inch diameter welded steel water pipe occasioned by R-wave propagation in Mexico City during the 1985 Michoacan earthquake. In this case, the special circumstances which lead to the damage was the very low propagation velocity of the R-waves in the Lake Zone of Mexico City. The second case history is girth weld failures to a 12 inch diameter gas pipeline occasioned by S-wave propagation in Potrero Canyon during the 1994 Northridge earthquake. In this case, the special circumstances which lead to the damage was very strong ground shaking combined with what turned out to be very poor welds.

1 January 2001 in Journal of Structural Engineering
Verified
Journal Article
Closed access
MOMichael O'ROurke
Michael O'ROurke
CDChris Downey
Chris Downey
A study of structural loading on gable roofs due to rain falling on an existing roof snowpack is presented. Rain-on-snow provisions in various existing standards are reviewed, and a summary of structural damage in the United States arguably related to rain-on-snow is presented. Three separate approaches are then used to quantify the intensity, duration, and return period for a rain-on-snow event. The first approach is case history information from a 1996/1997 rain-on-snow event (unknown return period). The second is a statistical approach in which the ground snow load plus daily rain with a 50-year return period is determined (unknown intensity and duration of the rain). The third is a two-year return period rain (unknown snow condition). Based upon the resulting roof surcharge loads, revised provisions for the ASCE 7 load standard are suggested. One possible revision is to only require a rain-on-snow surcharge for certain roofs with low slopes and short eave-to-ridge distances. An alternate revision is to simply eliminate the surcharge.