7 July 1997 in Applied Physics Letters
We report on quantum dot (QD) lasers made of stacked InAs dots grown by metalorganic chemical vapor deposition. Successful growth of defect-free binary InAs/GaAs QDs with high lateral density was achieved in a narrow growth parameter window. The room-temperature photoluminescence (PL) intensity is enhanced up to a factor of 3 and the PL peak width is reduced by more than 30% when a thin layer of is deposited onto the InAs QDs. A QD laser with a single sheet of such InAs/InGaAs/GaAs QDs exhibits threshold current densities as low as 12.7 and at 100 and 300 K, respectively. Lasers with threefold stacked QDs show ground-state lasing and allow for cw operation at room temperature.
1 May 2000 in IEEE Journal of Selected Topics in Quantum Electronics
The ultrafast gain and index dynamics in a set of InAs-InGaAs-GaAs quantum-dot (QD) amplifiers are measured at room temperature with femtosecond resolution. The role of spectral hole-burning (SHB) and carrier heating (CH) in the recovery of gain compression is investigated in detail. An ultrafast recovery of the spectral hole within /spl sim/100 fs is measured, comparable to bulk and quantum-well amplifiers, which is contradicting a carrier relaxation bottleneck in electrically pumped QD devices. The CH dynamics in the QD is quantitatively compared with results on an InGaAsP bulk amplifier. Reduced CH for both gain and refractive index dynamics of the QD devices is found, which is a promising prerequisite for high-speed applications. This reduction is attributed to reduced free-carrier absorption-induced heating caused by the small carrier density necessary to provide amplification in these low-dimensional systems.
1 June 2000 in IEEE Photonics Technology Letters
The ultrafast dynamics of gain and refractive index in an electrically pumped InAs-InGaAs quantum-dot (QD) optical amplifier are measured at room temperature using differential transmission with femtosecond time resolution. Both absorption and gain regions are investigated. While the absorption bleaching recovery occurs on a picosecond time scale, the gain compression recovers with /spl sim/100-fs time constant, making devices based on such dots promising for high-speed optical communications.
4 July 1996 in Electronics Letters
The authors compare the threshold current density jth against the laser length of a single layer quantum dot (SLQD) laser with a sixfold multilayer quantum dot (MLQD) laser. Gain saturation is not observed in the MLQD laser. They calculate jth against the number of dot layers including gain saturation. The strong impact of thermal coupling of carriers on jth is demonstrated.
15 September 1999 in Physical Review B
The room-temperature dephasing in InAs/GaAs self-assembled quantum dots is measured using two independent methods: spectal-hole burning and four-wave mixing. Dephasing times weakly dependent on the excitation density are found, with a low density value of from spectal-hole burning and of from four-wave mixing.
8 April 2002 in Applied Physics Letters
Postgrowth thermal annealing of an InGaN/GaN quantum-well sample with a medium level of nominal indium content (19%) was conducted. From the analyses of high-resolution transmission electron microscopy and energy filter transmission electron microscopy, it was found that thermal annealing at 900 °C led to a quasiregular quantum-dot-like structure. However, such a structure was destroyed when the annealing temperature was raised to 950 °C. Temperature-dependent photoluminescence (PL) measurements showed quite consistent results. Blueshift of the PL peak position and narrowing of the PL spectral width after thermal annealing were observed.