1 March 2017 in Microelectronics Reliability
1 December 2014 in Journal of Alloys and Compounds
1 August 2016 in Microelectronics Reliability
1 January 2016 in Materials & Design
6 September 2016 in The Journal of Physical Chemistry C
Nanoscale manipulation of atoms is desirable in modern technologies. Atoms in a material are normally manipulated by mechanical contact, or thermal and electric effects. The electron beam of a scanning electron microscope can also be utilised for patterning a substrate with nanoscale precision. Here we report stereoscopic growth of nanoparticles and nanorods on silver surfaces with nanometric precision using exposure to the electron beam in order to control position, size and orientation of nanorods. Nanorod length (50-1000 nm) and diameter (30-100 nm) can be independently controlled by adjusting the electron beam characteristics of a scanning electron microscope. Silver nanorods with diameters as small as 30 nm with location accuracy limited only by the resolution of the scanning electron microscope have been fabricated with repeatable orientation and size. New nanorods can even be grown directly on other nanorods. The results open up a number of exciting possibilities for three-dimensional, nanoscale controlled direct fabrication of nanoparticles and nanowires by an electron beam in situ using conventional SEM facilities.
1 July 2017 in Additional Conferences (Device Packaging, Hitec, Hiten, & Cicmt)
The surface oxidation of internal pore surfaces of nano-scale sintered silver has increased stability for high temperature applications. After treatment, high temperature storage at 400 °C has resulted in no changes to microstructure. By contrast, it is known that the microstructure of untreated pressure-less sintered silver continuously evolves at temperatures above 200 °C. Grain and pore growth occur in this temperature range for conventional sintered silver resulting in coarsening of the microstructure and increased susceptibility to fatigue. However, oxidation treatment of the internal pore surfaces has the effect of freezing the microstructure when the contact metallization is also silver or chemically inert. Oxidation prevents mass transfer by shutting down the fastest atomic migration route along the internal pore surfaces. Samples exhibited no change in microstructure either through continuous observation through glass, or after cross sectioning. The tested specimens under high temperature storage resisted grain growth for the whole duration of the tests of more than 600 h at 300 °C. The only detectable changes in microstructure occurred in a sparse number of isolated grains (1 in 7000 grains), presumably due to non-penetration of oxidising treatment into these closed pore spaces. It is hypothesized that even these can be prevented by minor changes to the sintering paste to slightly increase initial porosity. The oxidising treatment can be performed via many different routes, such as exposure to steam, or even by dipping in water for 10 min.