The mechanism for blob generation in a toroidal magnetized plasma is investigated using time-resolved measurements of two-dimensional structures of electron density, temperature, and plasma potential. The blobs are observed to form from a radially elongated structure that is sheared off by the flow. The structure is generated by an interchange wave that increases in amplitude and extends radially in response to a decrease of the radial pressure scale length. The dependence of the blob amplitude upon the pressure radial scale length is discussed.
The radial propagation of blobs generated from plasma instabilities is investigated in an open magnetic field line configuration. Blob cross-field velocities and sizes are obtained from internal probe measurements using pattern recognition. By varying the ion mass, the normalized vertical blob scale is scanned from to . An analytical expression for the blob velocity including cross-field ion polarization currents, parallel currents to the sheath, and ion-neutral collisions is derived and shows good quantitative agreement with the experimental data. In agreement with previous theoretical studies, this scaling shows that, for , the blob velocity is limited by cross-field ion polarization currents, while for it is limited by parallel currents to the sheath.
A unique parabolic relation is observed to link skewness and kurtosis of around ten thousand density fluctuation signals, measured over the whole cross section of a toroidal magnetized plasma for a broad range of experimental conditions. All the probability density functions of the measured signals, including those characterized by a negative skewness, are universally described by a special case of the Beta distribution. Fluctuations in the drift-interchange frequency range are necessary and sufficient to assure that probability density functions can be described by this specific Beta distribution.
2 March 2009 in Plasma Physics and Controlled Fusion
A steady-state, fully noninductive plasma current has been sustained for the first time in a tokamak using electron cyclotron current drive only. In this discharge, 123 kA of current have been sustained for the entire gyrotron pulse duration of 2 s. Careful distribution across the plasma minor radius of the power deposited from three 0.5-MW gyrotrons was essential for reaching steady-state conditions. With central current drive, up to 153 kA of current have been fully replaced transiently for 100 ms. The noninductive scenario is confirmed by the ability to recharge the Ohmic transformer. The dependence of the current drive efficiency on the minor radius is also demonstrated.