Woo-Seung Kim

Woo-Seung Kim

Auto-generated profile, based on publicly available information

Woo-Seung Kim

Department of Mechanical Engineering, Hanyang University, 55 Hanyangdaehak-ro, Sangnok-gu, Ansan 15588, Gyeonggi-do, Korea

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

1 April 2014 in Desalination
Verified
Journal Article
Closed access
JLJung-Gil Lee
Jung-Gil Lee
WKWoo-Seung Kim
Woo-Seung Kim


1 May 2015 in Desalination
Verified
Journal Article
Closed access
JLJung-Gil Lee
Jung-Gil Lee
YKYoung-Deuk Kim
Young-Deuk Kim
SSSung-Min Shim
Sung-Min Shim
BIBaek-Gyu Im
Baek-Gyu Im
WKWoo-Seung Kim
Woo-Seung Kim

1 September 2008 in Environmental Engineering Science
Verified
Journal Article
Closed access
SJSoo-Jin Jeong
Soo-Jin Jeong
SLSang-Jin Lee
Sang-Jin Lee
WKWoo-Seung Kim
Woo-Seung Kim
Optimization of the urea dosing system to maximize deNOx performance and to minimize NH3 slip during load changes is one of the main challenges for the mobile application of the urea–SCR (selective catalytic reduction) system. A mobile SCR system is restricted to a short distance between the engine exhaust and the catalyst entrance. Therefore, it is likely that urea residence time may not be adequate for complete thermolysis at the catalyst entrance. The key factors affecting the automobile application of SCR technology are the rapid thermolysis, good mixing of ammonia and gas, and reduction of ammonia slip. To this end, in the present study, the effects of the injection angle, urea injector location, and number of injection holes on the uniformity of the ammonia concentration distribution at the entrance of the SCR monolith as well as the maximum ammonia conversion efficiency have been examined in detailed three-dimensional numerical simulations under various engine loads of a heavy-duty diesel engine. As a result, the injection with an injection angle of 90° showed the best performance in terms of the maximum NH3 conversion efficiency. The effect of injector location more than 5D upstream was negligible in the uniformity point of view. Six- and eight-hole injectors showed no significant variation of uniformity with an injector location more than 5D, yielding over 95% of uniformity. Based on these results, the present work shows useful guidelines to achieve the optimum design of a urea–SCR injection system for improving deNOx performance and reducing ammonia slip.

7 February 2014 in International Journal of Energy Research
Verified
Journal Article
Closed access
PDF file
YJYusufu Abeid Chande Jande
Yusufu Abeid Chande Jande
MAM. Asif
M. Asif
SSS. M. Shim
S. M. Shim
WKW. S. Kim
W. S. Kim