In-situ efficiency determination of working motors in an industrial plant, if done nonintrusively, is less expensive than laboratory tests, which need disconnection of the motors from the loads. This paper presents a new approach to nonintrusive in-situ efficiency determination of an induction motor. By monitoring the input voltages, the input currents, the input power and the motor speed, an equivalent circuit based optimization process using the genetic algorithm calculates the motor efficiency. The convergence and the precision have been improved by taking into account several load points in the objective function, as well as the temperature dependency of the stator and rotor resistances. A sensitivity analysis of the method to parameter changes is also presented. Experimental results confirm. The validity of this method.
This paper presents three new architectures for designing accurate adaptive integration algorithms (AAIA) for quasi exact flux position and magnitude estimation of induction machines over a wide speed range. Pure integrators are in practice affected by DC-offset and DC-drift problems while estimating flux position and magnitude from the back electromotive force (emf). Modified integration algorithms based on low pass filter (LPF) or programmable LPF are also known to be affected by the cut-off frequency. The proposed architectures are based on the association of high pass filters (HPF) and pure integrators. DC-offsets and drift problems are eliminated by the HPFs before integration. The HPF characteristics are used for magnitude (gain) and position (angle) compensation. The HPF cut-off frequency can be chosen far from the inverse of stator time constant without affecting the estimation of low frequency signals resulting into good accuracy over a wide speed range. A strong agreement is observed between the simulation and experimental results that demonstrate the accuracy of the proposed architectures. The proposed AAIA can be used for any kind of induction machine (IM) since they are independent from the IM parameters. The AAIA can also be used to estimate stator flux in order to estimate the IM parameters online, as required for adaptive control in indirect rotor flux oriented control (IRFOC) schemes
The decoupling between the flux and torque is lost in an indirect rotor field oriented control if there is a mismatch between the controller programmed rotor time constant and the actual time constant of the motor. This occurs due to the heating and saturation of the magnetizing inductance of the motor. Adaptation of this rotor time constant is thus required, and it is necessary to estimate this parameter on-line in order to maintain it equal to its nominal value programmed in the decoupling controller. This paper presents a new control scheme for rotor time estimation using artificial neural networks (ANNs). This method, based on estimation of the rotor time constant from motor terminal variables (stator voltage, current and frequency), can be applied to the conventional (FOC) as well as to the artificial neural network control method (ANN-FOC) of vector control. The training of the ANN and the simulation of the drive system is presented. Presented results confirm the feasibility of the proposed scheme for conventional and ANN field oriented control implementations.