27 December 2024 in Measurement
20 October 2020 in SCIENTIA SINICA Informationis
Data analysis shows there are periodic systematic errors in the Doppler measurement of the Change-3 lunar probe. According to the Doppler measurement model and orbit information, as well as analysis of the Doppler information, periodic variation in the residuals is related to bias of the time-tag of the measurements. In this paper, self-calibration and differential statistical calibration methods are proposed to compensate this time-tag bias. The time-tag biases of the Jiamusi and Kashi deep space station estimated by these methods were 25 ms and 10 ms, respectively. The root mean square of the Doppler residual was reduced from 1.5 cm/s to 0.3 mm/s after the time-tag bias was compensated. The periodic variation in the residual was removed. In addition, the application of Doppler data in orbit determination was analyzed. Based on the orbit determination of ranging and VLBI data, the position error was only 2.5 m of the orbit determination using the compensated Doppler and VLBI data. The position deviation of the orbit determination obtained using the Doppler and ranging data was 25 m, and the position error of the orbit determination via Doppler data was 200 m.
5 June 2025 in Measurement Science and Technology
When an inclined geo-synchronous orbit satellite receives navigation signals, the long propagation distance and weak signal strength result in larger measurement noise and frequent cycle slips. The carrier smoothing code (CSC) filter improves the positioning and orbit determination (OD) capabilities by combining the high precision of carrier phase data and pseudorange data. This study first analyzes the quality of global positioning system (GPS) data received from the LT4A satellite, comparing its characteristics and delays with those of ground-based measurements. Subsequently, the Hatch filter is enhanced by a new real-time ambiguity estimation method and the Kalman filter calculates prediction values. This results in an improved filter that is well-suited for satellite-based measurements. Finally, the differences in measurement noise, positioning, and OD are compared for data without CSC processing, Hatch filter processing, and Improved filter processing. The results show that the improved filter reduces data noise to 0.23 m, representing an 80.2% decrease compared to the scenario without CSC processing, and suppresses 60.3% of the epochs with positioning errors exceeding about 50 m. The positioning errors processed by the Hatch filter and the Improved filter are about 189.44 m and 161.28 m, respectively, representing a 1.8% and 16.4% reduction compared to the scenario without CSC processing. For 72 h OD arcs, the OD accuracy is superior to that of 30 h arcs. The orbit overlap RMS for the two filters are 22.66 m and 17.96 m, respectively, representing reductions of 5.2% and 24.8% compared to the scenario without CSC processing. These findings demonstrate that the improved filter can better adapt to satellite-based measurements and enhance single-frequency onboard GPS receivers’ positioning and OD accuracy.