Xinfang Cui

Xinfang Cui

Auto-generated profile, based on publicly available information

Xinfang Cui

Technology and Engineering Center for Space Utilization, China Academy of Sciences, Beijing, China

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 February 2022 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
Haitao LiHaitao Li
Haitao Li
XCXiangwen Chen
Xiangwen Chen
GLGang Liu
Gang Liu
XCXinfang Cui
Xinfang Cui
High-precision position measurement of the gimbal servo system is indispensable to accurate torque output of the control moment gyroscope (CMG). This article addresses the systematic error of the resolver caused by the nonideal output signals of the resolver in the gimbal resolver-to-digital (R/D) conversion system. Due to the limitation of the structure and installation space of the CMG, it is impractical to install additional high-precision sensors to calibrate the raw angular position. Thus, this article proposes a new self-calibration method based on the discrete extended state observer (DESO) to compensate the systematic error of the resolver. The systematic error of the resolver is observed through iterating the resolver systematic estimation error and the compensation table is generated by the output of the DESO. Then, the steady-state error and dynamic performance of the DESO is analyzed and simulated. Finally, the proposed self-calibration method is verified by experiments, which show that the angular position control accuracy is significantly improved, which enhances the speed precision of the gimbal servo system.

4 November 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
Haitao LiHaitao Li
Haitao Li
XCXiangwen Chen
Xiangwen Chen
Haifeng ZhangHaifeng Zhang
Haifeng Zhang
XCXinfang Cui
Xinfang Cui
The high-precision control of angular speed in low-speed gimbal servo systems is an essential topic in the operation of the single gimbal control moment gyro (SGCMG). This article proposes a discrete control algorithm to suppress the influence of various disturbances on the low-speed gimbal servo system and the constraint between controller parameters and sampling time is established to ensure the stability of the system. To begin with, the disturbance analysis of the low-speed gimbal servo system is presented, including the torque ripple in the permanent magnet synchronous motor (PMSM), nonlinear friction, coupling torque caused by the spacecraft motion, and the parameter uncertainties. Then, a composite control method combining the sliding mode controller (SMC) with sliding mode observer (SMO) is applied to the speed loop and $q$ -axis current loop. The interferences are estimated by two SMOs, while SMCs are designed to eliminate the influence brought by the residual disturbances. The stability of the overall system is proven based on the Lyapunov criterion. Finally, simulation and experimental results verify the effectiveness of the proposed composite control method.