The conditions under which runaway electrons are generated in a gas diode with a strongly nonuniform electric field created by electrodes of specific geometry have been investigated. For an edge cathode, the equation of motion for electrons has been solved analytically. According to the solutions, for electrons to run away at the periphery, in the low field region, it is necessary that the applied potential difference be greater than a certain threshold determined by the electrode gap spacing and by the parameters of the gas. This condition supplements the classical electron runaway condition according to which the field strength near the emitting edge of the cathode should exceed some value depending only on gas parameters. It turned out that for a sharp-edged cathode, the new condition imposes more stringent requirements on the field strength compared with the classical one. Our calculations are supported by experiments in which electron runaway conditions were determined for a set of cathodes with different edge radii.
1 April 2016 in Journal of Experimental and Theoretical Physics
A wide class of exact solutions is obtained for the problem of finding the equilibrium configurations of charged jets of a conducting liquid; these configurations correspond to the finite-amplitude azimuthal deformations of the surface of a round jet. A critical value of the linear electric charge density is determined, for which the jet surface becomes self-intersecting, and the jet splits into two. It exceeds the density value required for the excitation of the linear azimuthal instability of the round jet. Hence, there exists a range of linear charge-density values, where our solutions may be stable with respect to small azimuthal perturbations.
The nonlinear dynamics of the interface between two deep dielectric fluids in the presence of a vertical electric field is studied. We consider the limit of a strong external electric field where electrostatic forces dominate over gravitational and capillary forces. The nonlinear integrodifferential equations for the interface motion are derived under the assumption of small interfacial slopes. It is shown in the framework of these equations that, in the generic case, the instability development leads to the formation of root singularities at the interface in a finite time. The interfacial curvature becomes infinite at singular points, while the slope angles remain relatively small. The curvature is negative in the vicinity of singularities if the ratio of the permittivities of the fluids exceeds the inverse ratio of their densities, and it is positive in the opposite case (we consider that the lower fluid is heavier than the upper one). In the intermediate case, the interface evolution equations describe the formation and sharpening of dimples at the interface. The results obtained are applicable for the description of the instability of the interface between two magnetic fluids in a vertical magnetic field.
The evolution of waves with finite amplitudes on the free surface of the ideal dielectric liquid in a strong tangential electric field is considered. It is shown that, in the case of a large permittivity of the liquid, nonlinear waves of arbitrary configuration can propagate in this system without distortions.
The influence of the space charge of ions emitted from the surface of a conical spike on its shape has been studied. The problem of the calculation of the spatial distributions of the electric field, ion velocity field, and the space charge density near the cone tip has been reduced to the analysis of a system of ordinary differential equations. As a result of numerical solution of these equations, the criterion for the balance of the capillary and electrostatic forces on the conic surface of a liquid-metal anode has been determined. It has allowed us to relate the electrical current flowing through the system, the applied potential difference, and the cone angle. We have compared the results of our calculations with available experimental data concerning emission from the surface of pure liquid gallium, indium, tin, and some liquid alloys, such as , , and . On the basis of the proposed model, explanations have been given for a number of specific features of the emissive behavior of different systems.