Ag/tungsten disulfide (WS2)–polyvinylpyrrolidone (PVP)/Cu memristors based on monolayer WS2 nanosheets and polyvinylpyrrolidone (PVP) nanocomposites were fabricated, and the influence of PVP content on the switching behaviors was investigated. The results indicate that the WS2–PVP based memristors show write-once read-many times (WORM) memory behavior. Remarkable resistive switching results such as a low operating voltage (VSET < 1 V), a high switching ratio (>103), good endurance (>100 cycles), and data retention time (>200 s) are obtained. With the increase in the PVP content, the device VSET gradually increases, and the switching ratio first slightly increases and then remarkably decreases. The double logarithm I–V curves verify that the switching mechanism of the devices is the trap-controlled space charge limited current mechanism, which is explained with the energy band diagram.
Porous graphene membranes (PGMs) have nanopores with single atomic thickness, which enables the precise and stable supply of ultralow flow rate gas below 10−14 Pa·m3·s−1. Different from a conventional channel, the surface diffusion (SD) process in PGM has become increasingly important and unique. However, the physical process and mathematical model of gas molecule transport in nanopores with single atomic thickness remain unclear. These inadequacies constrained the application of PGM in ultrasensitive leak detection. In this paper, the SD process in PGM was investigated using molecular dynamics simulation. A test rig was constructed to verify the simulation results. The nanopores in PGM were quantitatively characterized using a transmission electron microscope. Results show that a transfer region encircling the nanopores was identified, which plays a crucial role in the SD process. Furthermore, the physical model of SD process is described with a two-step model. Finally, a mathematical model of the SD process is established and validated. This paper provides nanoscale insights for an in-depth understanding of the SD process in PGM and promotes ultrasensitive leak detection technology.
This work presents a new low-voltage, magnetic-less ion pump that utilizes the pyroelectric principle. Both the electron emission and high-voltage to realize an ion pump are supplied by pyroelectric material, whose activation only requires 5 V drive voltage. Structure optimization of the pyroelectric ion pump is carried out in order to reduce outgassing during an operating period to achieve a better pumping performance. The outgassing characteristics of the optimized ion pump are investigated by simulation and experiment, and its pumping performance is experimentally tested and the pumping speed is calculated using experimental data. The results show that the outgassing of a Ti tube structure ion pump is approximately two-orders-of-magnitude lower compared to that of a Ti plate structure ion pump. The pyroelectric ion pump can further reduce the system limiting pressure from 2.8 × 10−6 Pa achieved by a turbomolecular pump unit to 1.81 × 10−6 Pa, with the estimated pumping rate of 1.6 l/s that exceeds most reported magnetic-less ion pumps. The pyroelectric ion pump demonstrates great potential in low-drive voltage, magnetic-less high-vacuum pumping for the high precision sensors using atomic interferometers technology.