Zaiping Nie

Zaiping Nie

Auto-generated profile, based on publicly available information

Zaiping Nie

University of Electronic Science and Technology of China

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 November 2017 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
HZHangyu Zhang
Hangyu Zhang
SYShiwen Yang
Shiwen Yang
YCYikai Chen
Yikai Chen
JGJixin Guo
Jixin Guo
ZNZaiping Nie
Zaiping Nie
Previous studies on tightly coupled dipole arrays (TCDAs) are mainly focused on 2-D phased arrays, where very wide bandwidth can be achieved as compared to 1-D TCDAs. Moreover, for the dual-polarized case, the inter-element coupling is not sufficient in the polarization along the transverse direction of linear array, which leads to a much narrower bandwidth. In this communication, a wideband dual-polarized tightly coupled dipole linear array (TCDLA) is proposed. A novel vertical parasitic superstrate layer is employed in the dual-polarized linear array to compensate the impedance variation in beam scanning cases. As compared to traditional wide-angle impedance matching layer composed of layered dielectric sheets, the vertical parasitic superstrate layer greatly reduces the weight of the array. Simulation results show that the TCDLA achieves 5:1 bandwidth and 4:1 bandwidth in the vertical polarization and horizontal polarization, respectively, for VSWR <; 3.0:1, while scanning up to ±60°. Prototype for a 1 × 26 linear array is fabricated and measured. Good agreement is achieved between measured and simulation results.

12 March 2018 in IEEE Transactions on Signal Processing
Verified
Journal Article
Closed access
Qianli WangQianli Wang
Qianli Wang
ZZZhiqin Zhao
Zhiqin Zhao
ZCZhuming Chen
Zhuming Chen
ZNZaiping Nie
Zaiping Nie
Off-grid direction of arrival (OGDOA) estimation methods deal with the situations where true direction of arrivals (DOAs) are not on the discretized sampling grid. However, existing OGDOA estimation methods are faced with a tradeoff between density of initial grid and computational workload. Furthermore, these methods fail if more than one true DOA is located in a same grid interval. In order to speed up the OGDOA estimation methods and solve the problem of more than one DOA in one initial grid interval, a grid evolution direction of arrival (GEDOA) estimation method is proposed. Based on the combination of OGDOA estimation methods and grid refinement, this new approach makes the grid nonuniformly evolve from coarse to dense. The proposed method contains two subprocesses, i.e., learning process and fission process. The learning process aims to update locations of grid points and estimate DOAs. The fission process aims to generate new grid points and guarantees that there is only one DOA in a grid interval. The two processes iterate alternatively. Finally, an adaptive and nonuniform grid and an estimated spatial spectrum based on this grid are achieved. Compared with the previous methods, GEDOA has better computational efficiency because fewer grid points are used at each iteration. Furthermore, GEDOA has better resolution and lower MSE at relative high SNR. This is because that the evolved grid obtained by this new approach is information adaptive. Numerical simulations validate the effectiveness of the proposed method.

8 January 2021 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
LYLu Yin
Lu Yin
PYPeng Yang
Peng Yang
YGYuyi Gan
Yuyi Gan
FYFeng Yang
Feng Yang
SYShiwen Yang
Shiwen Yang
ZNZaiping Nie
Zaiping Nie
In this article, we present a low-cost microstrip phased-array antenna, which is composed of electronically reconfigurable elements. The p-i-n diodes' integrated elements have various functions, such as tunable polarization characteristics and adjustable radiation phases. The high sidelobe level (SLL) due to the 2-bit phase shifter can be reduced by a randomly rotated (RR) array element. It is shown that the array can realize electronic beam-steering capabilities and keep -10 to -14 dB sidelobes without tapering. To verify the above theory, an eight-element linear array prototype working at 3 GHz was designed, fabricated, and tested. Numerical simulations and experimental results show that, by controlling the “ON” and “OFF” states of p-i-n diodes, the radiation beam can be controlled to steer in a circular polarization (CP) mode, wherein the scanning angle is up to ±45°. Furthermore, the principle of suppressing the vector scattering field by the opposite phasing cancellation method can achieve in-band radar cross section (RCS) reduction. Simulation results show that approximately 15 dB in-band RCS reduction can be realized for both bistatic and monostatic RCS reduction with an 8×8 array.

13 July 2017 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
PLPeng-Fa Li
Peng-Fa Li
SQShi-Wei Qu
Shi-Wei Qu
SYShiwen Yang
Shiwen Yang
ZNZai-Ping Nie
Zai-Ping Nie
A microstrip planar array antenna is presented in this paper, which is designed to have near-field focused beams, and it is capable of steering its focus on the designed focal plane. The array is composed of eight series-fed linear arrays, which are able to scan the focus by frequency around 10 GHz in the H-plane, whereas, E-plane focus scan can be achieved by feeding the linear arrays with different phases. The proposed array can be used in near-field scan systems, e.g., microwave imaging system, with a faster scan rate than mechanically scanned antennas and a lower cost than array antennas with full phase control elements. Theoretical analysis is presented in this paper, and is verified by simulations and experiments.

9 December 2021 in IEEE Antennas and Wireless Propagation Letters
Verified
Journal Article
Closed access
WLWenjin Li
Wenjin Li
YZYanwen Zhao
Yanwen Zhao
XDXiaoxiang Ding
Xiaoxiang Ding
LWLifeng Wu
Lifeng Wu
ZNZaiping Nie
Zaiping Nie
In this letter, a pattern-reconfigurable antenna for indoor communication is proposed, which can provide stable conical and broadside beams. Although this type of pattern-reconfigurable antenna can provide large radiation coverage, it usually suffers complex structure, narrow bandwidth, and distorted pattern. In order to get rid of the complex radiators, a simple loop patch is introduced to generate the conical and broadside beams. Through slotting the loop patch with the aid of characteristic mode analysis, the two desired radiation modes can be well excited in the same band. Meanwhile, the modified loop patch can provide stable radiation patterns by suppressing unwanted higher order modes. For achieving the reconfigurable beams, a reconfigurable feeding network is designed to switch two working modes. Finally, the proposed pattern-reconfigurable antenna is fabricated, and the measured overlapped 10 dB operating bandwidth is about 27.3% ranging from 3.61 to 4.75 GHz. The results show that the proposed pattern-reconfigurable antenna has a wide bandwidth and stable radiation patterns, which exhibits attractive potentials for fifth-generation (5G) indoor communication in sub-6 GHz.

17 January 2020 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
QSQiang Sun
Qiang Sun
YBYong-Ling Ban
Yong-Ling Ban
Ji-Wei LianJi-Wei Lian
Ji-Wei Lian
YLYanhui Liu
Yanhui Liu
ZNZaiping Nie
Zaiping Nie
A millimeter-wave (mm-wave) multibeam array antenna based on folded C-type substrate integrated waveguide (FCSIW) is presented for the first time. The design steps for its two main elements are described, namely a FCSIW Butler Matrix (BM) and a FCSIW single branch slot array antenna. Both of them exhibit a significant miniaturization in comparison with their SIW counterparts, leading to 40% and 33.2% reduction in occupied surface for the BM and the whole multibeam array antenna while maintaining similar performances, respectively. In addition, an optimized transition connection structure from ground coplanar waveguide (GCPW) to FCSIW is designed to facilitate the measurement of the multibeam array antenna. Finally, the FCSIW multibeam array antenna is optimized, manufactured and measured, which can help verify the feasibility of FCSIW for the miniaturized multibeam array antenna.