Katarína Ridzoňová

Katarína Ridzoňová

Auto-generated profile, based on publicly available information

Katarína Ridzoňová

FZU—Institute of Physics of the Czech Academy of Sciences, Na Slovance 1999/2, 182 00 Prague, Czech Republic

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 March 2019 in Energy & Environmental Science
Verified
Journal Article
Closed access
PDF file
AMArtem Musiienko
Artem Musiienko
PMPavel Moravec
Pavel Moravec
RGRoman Grill
Roman Grill
PPPetr Praus
Petr Praus
IVIgor Vasylchenko
Igor Vasylchenko
MAMahshid Ahmadi
Mahshid Ahmadi
Understanding the type, formation energy and capture cross section of defects is one of the challenges in the field of organometallic halide perovskite (OMHP) devices. Currently, such understanding is limited, restricting the power conversion efficiencies of OMHP solar cells from reaching their Shockley–Queisser limit. In more mature semiconductors like Si, the knowledge of defects is one of the major factors in successful technological implementation. This knowledge and its control can make a paradigm shift in the development of OMHP devices. Here, we report on deep level (DL) defects and their effect on the free charge transport properties of the single crystalline methylammonium lead bromide (MAPbBr3) perovskite. To determine DL activation energy and capture cross section, we used photo-Hall effect spectroscopy (PHES) with enhanced illumination in both steady-state and dynamic regimes. This method has shown to be convenient due to the direct DL visualization by sub-bandgap photo-excitation of trapped carriers. DLs with activation energies of EV + 1.05 eV, EV + 1.5 eV, and EV + 1.9 eV (or EC − 1.9 eV) were detected. The hole capture cross section of σh = 4 × 10−17 cm2 is found using photoconductivity relaxation after sub-bandgap photo-excitation. Here, our experimental results demonstrate the existence of DL defects responsible for non-radiative recombination and their positions inside the bandgap for the first time. Additionally, the transport properties of single crystal MAPbBr3 are investigated by Time of Flight (ToF) measurements at several biases. These measurements further confirm the increase of Hall mobility and the enhancement of hole transport produced by sub-bandgap illumination in MAPbBr3 devices. The analysis of charge carrier transport by ToF measurements in combination with the energy of DLs identified by PHES can explain the long hole carrier lifetime in MAPbBr3 devices, while the electron carrier lifetime is largely affected by trap-assisted recombination. Here, our studies provide strong evidence for deep levels in OMHPs and open a richer picture of the role and properties of deep levels in MAPbBr3 single crystals as a system model for the first time. The deeper knowledge of the electronic structure of OMHPs could open further opportunities in the development of more feasible technologies. Indeed, knowledge of the exact positions of DLs is beneficial in controlling these defects by crystal growth modification to eliminate these defects as was done for classical inorganic semiconductors, for example, in Si, GaAs, and CdTe development.

25 August 2022 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
KRKatarína Ridzoňová
Katarína Ridzoňová
RGRoman Grill
Roman Grill
Amalraj Peter AmalathasAmalraj Peter Amalathas
Amalraj Peter Amalathas
BDBranislav Dzurňák
Branislav Dzurňák
Neda NeykovaNeda Neykova
Neda Neykova
JHJakub Holovský
Jakub Holovský
Mixed-halide perovskites are highly promising materials for tandem solar cells. The phenomenon of phase segregation, however hinders their application. Here, we combine Fourier-Transform photocurrent spectroscopy with photoluminescence and current density–voltage (J–V) measurements to study the effect of light soaking on such materials and devices. At first, we observe a gradual formation of an I-rich phase, which correlates with an increase in deep defect level concentration. We attribute these deep defects to charged iodide interstitials and associate phase segregation with iodide migration through interstitial positions. Upon further light soaking, the second less I-rich phase forms, while the deep level concentration simultaneously decreases. An empirical model describing the phase segregation mechanism is proposed to rationalize these observations. Further, we point to an important role of grain size in determining the degree and terminal phase of segregation.

22 June 2020 in Physical Review Applied
Verified
Journal Article
Closed access
PDF file
KRKatarina Ridzonova
Katarina Ridzonova
EBEduard Belas
Eduard Belas
RGRoman Grill
Roman Grill
JPJakub Pekarek
Jakub Pekarek
PPPetr Praus
Petr Praus
We combine steady-state photoconductivity and laser-induced transient current measurements under above-band-gap illumination to study space-charge formation in (Cd,Zn)Te. Analytical and numerical models describing space-charge-limited photocurrents are developed and excellent agreement with measured data is obtained, especially with the Drift-diffusion model. A linear rise of photocurrent at low voltage is observed and ascribed to the trapping of injected holes in the region close to the cathode side. The influence of space-charge formation, the influence of photoconductive gain, and the contribution of shallow and deep levels to photocurrent-voltage characteristics are numerically simulated. According to measurements and calculations, recent principles used to evaluate detector properties, mainly the mobility-lifetime product, via the photoconductivity are critically assessed.

22 April 2023 in Materials
Verified
Journal Article
Open access
PDF file
MBMaksym Buryi
Maksym Buryi
VBVladimir Babin
Vladimir Babin
Neda NeykovaNeda Neykova
Neda Neykova
YWYu-Min Wang
Yu-Min Wang
ZRZdenek Remes
Zdenek Remes
OPOgnen Pop-Georgievski
Ognen Pop-Georgievski
The influence of Mo on the electronic states and crystalline structure, as well as morphology, phase composition, luminescence, and defects in ZnO rods grown as free-standing nanoparticles, was studied using a variety of experimental techniques. Mo has almost no influence on the luminescence of the grown ZnO particles, whereas shallow donors are strongly affected in ZnO rods. Annealing in air causes exciton and defect-related bands to drop upon Mo doping level. The increase of the Mo doping level from 20 to 30% leads to the creation of dominating molybdates. This leads to a concomitant drop in the number of formed ZnO nanorods.

13 June 2019 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
PDF file
JZJakub Zazvorka
Jakub Zazvorka
JPJakub Pekárek
Jakub Pekárek
RGRoman Grill
Roman Grill
EBE Belas
E Belas
KRKatarína Ridzoňová
Katarína Ridzoňová
JFJan Franc
Jan Franc
Cadmium telluride (CdTe) and its compounds are the materials of choice for producing industrial quality hard x-ray and gamma ray detectors with high spectral resolution and signal-to-noise ratio. However, optimization of the growth process still proves challenging as the yield is small due to inhomogeneities in the material parameters. Here we investigated the influence of inhomogeneous resistivity on charge collection efficiency of CdZnTe radiation detectors operating at high photon fluxes of incoming radiation. We applied a complex of experimental methods—contactless resistivity and photoconductivity mapping, photoluminescence and laser-induced transient current technique. We observed that the charge collection efficiency at low fluxes is nearly independent of resistivity, while at high fluxes the performance of high resistivity part substantially decreases when compared to the lower resistivity part. This behavior is explained by characteristic evolution of defect structure attaining shallow defect self-compensation during the cooling of the solidified crystal. Instabilities at impurity segregation and temperature gradients at the crystal growth cause different concentration of defects that manifest themselves as deep energy levels within the material bandgap. The defect self-compensation is successfully simulated by theoretical model considering defect reactions in tellurium-saturated CdZnTe.