1 November 2023 in Journal of Renewable and Sustainable Energy
The sea area in China demands high requirements for water depth adaptability, stability, structural integrity, dynamic response characteristics, and economic performance of large-scale floating wind turbines (FWTs). The aim of the research is to propose the 10 megawatts (MW) SPIC concept (Semi-submersible platform with Partially Inclined Columns, SPIC for short) FWT in intermediate water depth, providing guidance for the concept design of large-scale FWT. The SPIC concept FWT incorporates partially tilted outward side columns, which effectively minimize the risk of bottom contact and significantly enhance the stability of the floating wind turbine. This is achieved by increasing the inertia moment of the waterplane without increasing the displaced water or water surface area. The 10 MW SPIC concept FWT exhibits superior performance in terms of smaller static heeling angle, motion amplitude response function, and wave force transfer function. It also features lower steel consumption and less displaced water, achieving good stability, hydrodynamic performance, and low cost. The rationality of the concept design and the accuracy of the numerical simulation process were validated in this study using experimental results. The study assessed the extreme responses of the 10 MW SPIC concept FWT in its six degrees of freedom (DOFs) under various scenarios, including power production, power production with faults, parked condition, and parked condition with faults, thus verifying the safety of the SPIC concept.
1 November 2023 in Journal of Renewable and Sustainable Energy
Rotor redesign approaches have been widely proposed to solve the thrust mismatch issue caused by scaling effects for basin model tests of horizontal axis floating wind turbines (FWTs). However, limited basin model tests utilized the thrust-matched rotor (TMR) to accurately evaluate the aerodynamic loads applying to the vertical axis FWTs. This paper described the detailed design approach of the TMR of floating straight-bladed vertical axis wind turbines (VAWTs) with a rated power of 5.3 MW. First, the AG455 airfoil was selected to replace the NACA0018 airfoil. AG455 airfoil can show a larger lift coefficient and a smaller drag coefficient at low Reynolds number. On this basis, the load distribution match algorithm was used to assign the blade pitch angle and chord length at each section of the blade. This method takes the spanwise load and load change rate of model-scaled blade and full-scaled blade as the constraint conditions. By adopting this method, the rotor thrust can be tailored to match the prototype values across a wide range of tip speed ratios. This design approach proves advantageous in assessing the aerodynamic performance of VAWTs under varying inflow wind speeds and unsteady wind conditions. The redesigned TMR model under low Reynolds number can meet Froude similarity criterion, which is helpful to improve the accuracy of vertical axis FWT model tests in the wave basin.
20 November 2025 in Ocean Engineering