14 May 2021 in International Journal of Rotating Machinery
In order to study the icing mechanism and anti-icing technology, a small low-speed reflux icing wind tunnel test system was designed and constructed. The refrigeration system and spray system were added to the small reflux low-speed wind tunnel to achieve icing meteorological conditions. In order to verify the feasibility of the test system, the flow field uniformity, temperature stability, and liquid water content distribution of the test section were tested and calibrated. On this basis, the icing tests of an aluminium cylinder, an NACA0018 airfoil, and an S809 airfoil were carried out, and the two-dimensional ice shape obtained by the test was compared with the two-dimensional ice shape obtained by the numerical simulation software. The results show that in the icing conditions and icing time studied, the parameters of the test system are stable, and the experimental ice shape is consistent with the simulated ice shape, which can meet the needs of icing research.
3 November 2020 in International Journal of Rotating Machinery
To determine the process of icing on the rotating machinery, an icing experiment on a rotating airfoil blade was carried out in this paper. First, an icing wind tunnel was fabricated, and its conditional parameters were calibrated. The calibration results showed that the performance of this icing wind tunnel was reliable and stable. The experimental temperature was -15C, and the MVD was 50μm. Then, an icing experiment on the rotating blade with the NACA0018 airfoil was carried out. The characteristics of icing, including icing distribution, growth rate of icing, and thickness of the ice layer, were defined and quantitatively analyzed under different tip speed ratios and setting angles. The results show that the type of icing changes from rime ice to glaze ice with an increase in the tip speed ratio. The dimensionless icing area and dimensionless thickness of the ice layer both increase with an increase in the icing time. The growth rate of icing increases rapidly at the initial icing stage and then decreases dramatically under each tip speed ratio condition.
8 November 2021 in International Journal of Rotating Machinery
Ice accumulation on the blade of a wind turbine surface seriously threatens the operational safety of the turbine; therefore, the research on this problem is very important. In this paper, a new similarity criterion of icing shape for a rotational model was proposed based on the similarity criterion for translational motion models in the aviation field, and experimental studies on the similarity of the rotational model icing were carried out. To validate the similarity criterion, icing wind tunnel tests were carried out with aluminum cylinders with diameters of 40 mm and 20 mm. Key parameters for the experiment, such as wind speed, temperature, liquid water content, medium volume diameter, and test time, were selected based on the criterion. All the icing tests were carried out in a new self-designed icing wind tunnel test system based on natural low-temperature conditions. The icing shapes observed in the tests were confirmed after many repetitions. To quantitatively analyze the similarity between different sizes of ice shapes, a dimensionless method for evaluating the similarity of ice shapes of different sizes was defined based on the typical characteristics of ice shapes. The research results show that the similarity score between two sizes of ice shapes under different test conditions is 81%~90%. The accuracy and applicability of the icing shape similarity criterion were thus validated. The research results in this paper lay a theoretical and experimental foundation for exploring the icing shape similarity of a rotating model.