16 February 2018 in Soft Matter
Reversible control of mechanical hysteresis of complex materials by applied stress.
12 May 2021 in Soft Matter
Cells dynamically control their material properties through remodeling of the actin cytoskeleton, an assembly of cross-linked networks and bundles formed from the biopolymer actin. We recently found that cross-linked networks of actin filaments reconstituted in vitro can exhibit adaptive behavior and thus serve as a model system to understand the underlying mechanisms of mechanical adaptation of the cytoskeleton. In these networks, training, in the form of applied shear stress, can induce asymmetry in the nonlinear elasticity. Here, we explore control over this mechanical hysteresis by tuning the concentration and mechanical properties of cross-linking proteins in both experimental and simulated networks. We find that this effect depends on two conditions: the initial network must exhibit nonlinear strain stiffening, and filaments in the network must be able to reorient during training. Hysteresis depends strongly and non-monotonically on cross-linker concentration, with a peak at moderate concentrations. In contrast, at low concentrations, where the network does not strain stiffen, or at high concentrations, where filaments are less able to rearrange, there is little response to training. Additionally, we investigate the effect of changing cross-linker properties and find that longer or more flexible cross-linkers enhance hysteresis. Remarkably plotting hysteresis against alignment after training yields a single curve regardless of the physical properties or concentration of the cross-linkers.
19 December 2019 in Journal of Physics: Condensed Matter
Under an increasing applied shear stress ( ), the viscosity of many dense particulate suspensions increases drastically beyond a stress onset ( ), a phenomenon known as discontinuous shear-thickening. Recent studies point out that some suspensions can transform into a stress induced solid-like shear jammed (SJ) state at high particle volume fraction ( ). SJ state develops a finite yield stress and hence is distinct from a shear-thickened state. Here, we study the steady state shear-thickening behaviour of dense suspensions formed by dispersing colloidal polystyrene particles (PS) in polyethylene glycol (PEG). We find that for small values the viscosity of the suspensions as a function of can be well described by Krieger–Dougherty (KD) relation. However, for higher values of ( ), KD relation systematically overestimates the measured viscosity, particularly for higher values. This systematic deviation can be rationalized by the weakening of the sample due to flow induced failures of the solid-like SJ state. Using Wyart–Cates model, we propose a method to predict the SJ onset from the steady state rheology measurements. Our results are further supported by in situ optical imaging of the sample boundary under shear.
23 June 2022 in Physical Review Letters
Many dense particulate suspensions show a stress induced transformation from a liquidlike state to a solidlike shear jammed (SJ) state. However, the underlying particle-scale dynamics leading to such striking, reversible transition of the bulk remains unknown. Here, we study transient stress relaxation behaviour of SJ states formed by a well-characterized dense suspension under a step strain perturbation. We observe a strongly nonexponential relaxation that develops a sharp discontinuous stress drop at short time for high enough peak-stress values. High resolution boundary imaging and normal stress measurements confirm that such stress discontinuity originates from the localized plastic events, whereas system spanning dilation controls the slower relaxation process. We also find an intriguing correlation between the nature of transient relaxation and the steady-state shear jamming phase diagram obtained from the Wyart-Cates model.
26 May 2022 in Communications Physics
Shear induced yielding in disordered solids, characterized by irreversibility and enhanced dissipation, is important for a wide range of industrial and geological processes. Although such phenomena in thermal systems have been extensively studied, they remain poorly understood for granular solids. Here, using oscillatory shear rheology we study energy dissipation in a disordered solid formed by dense granular suspensions of adhesive frictional particles. We find non-linear flow regimes showing intra-cycle strain stiffening and plasticity that strongly depend on both the applied strain amplitude and particle volume fraction, which can be captured by the normalized energy dissipation. Furthermore, in-situ optical imaging reveals irreversible particle rearrangements correlating with the spatio-temporal fluctuations in local velocity across the yielding transition. By directly measuring the critical jamming packing fraction using particle settling experiments, we propose a phase diagram that unravels the effect of inter-particle interactions on flow properties of the system for a large parameter space.
22 June 2022 in The Journal of Chemical Physics
Repeated/cyclic shearing can drive amorphous solids to a steady state encoding a memory of the applied strain amplitude. However, recent experiments find that the effect of such memory formation on the mechanical properties of the bulk material is rather weak. Here, we study the memory effect in a yield stress solid formed by a dense suspension of cornstarch particles in paraffin oil. Under cyclic shear, the system evolves toward a steady state showing training-induced strain stiffening and plasticity. A readout reveals that the system encodes a strong memory of the training amplitude (γT) as indicated by a large change in the differential shear modulus. We observe that memory can be encoded for a wide range of γT values both above and below the yielding albeit the strength of the memory decreases with increasing γT. In situ boundary imaging shows strain localization close to the shearing boundaries, while the bulk of the sample moves like a solid plug. In the steady state, the average particle velocity inside the solid-like region slows down with respect to the moving plate as γ approaches γT; however, as the readout strain crosses γT, suddenly increases. We demonstrate that inter-particle adhesive interaction is crucial for such a strong memory effect. Interestingly, our system can also remember more than one input only if the training strain with smaller amplitude is applied last.