In the high-power laser facility (SG-III), focusing 48 laser beams into the target center better than 50 microns (RMS) within a few picoseconds is dependent on the stringent specifications of thousands of large optics and also puts huge challenges on the engineering characteristics of the design and mounting. A parametric optomechanical method is proposed to evaluate the performance of a 400 mm large-aperture transport mirror. With theoretical modeling and numerical analysis, the impacts of assembly structure, manufacturing errors, mounting loads, and gravity on the mirror surface aberrations are calculated and discussed in detail. With field experiments and case studies, the proposed method shows a powerful performance on the mirror surface aberrations’ evaluation, and negative impacts of currently used mounting techniques for the mirror are found. Finally, a new assembly design is presented based on a discussion of its advantages.
The effective energy density at the target of inertial confinement fusion facility is subject to the problem of the low efficiency of second harmonic generation of large-aperture KDP frequency converters over a long time. To overcome this problem, we propose the optomechanical analysis method to correlate the mechanical factors with its critical physical performance in theory. Further, combined with experiments and simulations, the mechanical sensitivity of the frequency converter is completely explained from the microscopic and macroscopic perspectives. Finally, we introduce a moment-dominated clamping scheme that is expected to greatly improve the online service performance of the converter.
Motivated by the demand to minimize the mount-induced wavefront aberration of the large-aperture laser transport mirror, a low-stress flexure mounting configuration is proposed. Specific optomechanical analyses, including theoretical modeling, numerical analysis and field experiment, are presented. The mechanical properties of the flexure support were studied specifically. Besides, the relation between the mounting forces and the root-mean-square of the gradients (GRMS) value of the mirror surface is studied. Then, the appropriate value of the bolt preload is set to 500N, with which the GRMS value is just . The results indicate that the flexure mounting configuration is indeed a feasible and promising method to solve the mount-induced distortion problem of large-aperture optics.