Organic nanorods have been prepared to be assembled with carbon monoxide dehydrogenase for photobiocatalytic CO2 reduction. The surfactants used to synthesize organic nanorods have shown significant effect on the performance of biohybrid assemblies.
We demonstrate that the insertion of the dinuclear active site of [FeFe] hydrogenase into the apo-enzyme can occur when the enzyme is embedded in a film of redox polymer, under conditions of mediated electron transfer.
Many environmentally relevant electrocatalytic reactions proceed via proton coupled electron transfer (PCET) mechanisms, which are not only dependent on highly active surface catalysts, but also on favorable local pH conditions. To that end, protic polymer coatings have been reported to promote PCET-reactions. However, they modulate the local reaction environment in numerous ways obscuring meaningful conclusions on the origin of this promotion. To deconvolute the effect of local pH in protic polymer-coatings from other contributions we developed a method for operando determination of in-polymer pH values using electrochemical fluorescence microscopy. Polyethylene imine (PEI) was equipped with a fluorescent pH probe, coated on polycrystalline gold and electrochemical hydrogen evolution was applied as a pH-sensitive model reaction. Temporal changes of the average pH values throughout the whole thickness of the polymer film were quantified by widefield microscopy, while the spatial distribution of pH-profiles within the films were determined by confocal laser scanning microscopy (CLSM). Complementing the experimental results with finite-element modeling identified two polymer induced effects: i) local differences in the mass transport of the proton donors and ii) a pronounced local buffering by the highly concentrated ammonium groups inside the polymer-coating. The latter was corroborated by linear sweep voltammetry (LSV): While the buffering PEI-coating decreased the onset potential of hydrogen evolution, a control polymer (polyvinyl alcohol), which cannot be deprotonated in the aqueous pH-window, did not promote electrocatalysis. These findings highlight the operando pH-modulation by protic polymer coatings and understanding this phenomenon will be crucial for rational design of polymer-coatings for PCET-reactions.
6 October 2026 in Journal of the American Chemical Society
Many electrocatalytic reactions proceed via proton-coupled electron transfer (PCET) mechanisms, which can be promoted by protic polymer coatings. However, polymers modulate the local reaction environment in many ways. To deconvolute the effect of local pH in protic polymer coatings from other contributions, we developed a method for operando determination of in-polymer pH values using electrochemical fluorescence microscopy. Polyethylenimine (PEI) was equipped with a fluorescent pH probe, coated on polycrystalline gold, and electrochemical hydrogen evolution was applied as a pH-sensitive model reaction. Temporal changes in the average pH values across the entire thickness of the polymer film were quantified by widefield microscopy, while the spatial distribution of pH profiles within the films was determined by confocal laser scanning microscopy (CLSM). Complementing the experimental results with finite-element modeling identified two polymer-induced effects: (i) local differences in the mass transport of the proton donors and (ii) a pronounced local buffering by the highly concentrated ammonium groups inside the polymer coating. The latter was corroborated by linear sweep voltammetry (LSV): while the buffering PEI coating decreased the onset potential of hydrogen evolution, the control polymers poly(vinyl alcohol) and PiperION, which cannot be deprotonated in the aqueous pH window, did not promote electrocatalysis. These findings highlight the operando pH modulation by protic polymer coatings, and understanding this phenomenon will be crucial for rational design of polymer coatings for PCET reactions.