29 November 2004 in Applied Physics Letters
Praseodymium silicate (Pr silicate) has been synthesized by molecular-beam deposition of layers on Si(111) substrates and subsequent high-temperature postdeposition annealing at 1000 °C. This thermal treatment drastically changes the film texture from the crystalline epitaxially grown on Si, into Pr silicate with completely amorphized structures, resulting from intermixing of Si from the substrate. It was found that the electrical characteristics of Pr silicate were critically dependent on the quality of the as-deposited films. A typical dielectric constant and a leakage current density of Pr silicate grown under an optimal condition were, respectively, 19.7 and at +1 V relative to the flatband voltage for an equivalent oxide thickness of 1.9 nm. Using x-ray photoelectron spectroscopy, a valence-band offset at the Pr-silicate/Si(111) interface of 2.75 eV and a band gap of 6.50 eV were obtained. The large band gap and the highly symmetric band alignment account for the observed low leakage current density.
12 November 2001 in Applied Physics Letters
A method to obtain high-quality strain–relaxed SiGe buffer layers on Si(001) substrates is presented. In this method, the strain relaxation of the SiGe layer is performed using a two-step procedure. Firstly, a low-temperature-grown SiGe layer, whose surface is covered by a thin Si cap layer, is thermally annealed. At this stage, the strain is incompletely relaxed and an atomically flat surface can be realized. Then, a second SiGe layer is grown on the first layer to achieve further strain relaxation. Transmission electron microscopy has clearly revealed that dislocations are dispersively introduced into the first SiGe/Si substrate interface and thus no pile up of dislocations occurs. The formation of a periodic undulation on the growth surface of the second SiGe layer is the key to inducing a drastic reduction in the threading dislocation density.
1 April 1997 in Applied Surface Science
17 July 1989 in Applied Physics Letters
Superconducting thin films of Y‐Ba‐Cu‐O oxide have been prepared on (100) MgO substrates by flash evaporation in oxygen plasma. The as‐grown films deposited at substrate temperatures from 385 to 550 °C show superconducting properties with a critical temperature Tc of about 90 K. Transmission electron diffraction indicates that a film deposited at below 430 °C has both amorphous and polycrystalline regions, and that a film at above 430 °C is polycrystalline.
30 April 2002 in Japanese Journal of Applied Physics
We have investigated nitridation processes on clean Si(100)-2×1 surfaces and the electrical characteristics of metal-insulator-semiconductor (MIS) capacitors with nitride films formed by radical nitrogen. The radical nitrogen exposure to Si surfaces at 500°C initially causes both nitridation of Si and local detachment reactions on the surface. It is found from scanning tunneling microscopy and scanning tunneling spectroscopy that the nitridation proceeds in a layer-by-layer manner in which a continuous film is formed by the coalescence of two-dimensional islands. At nitride thicknesses above 0.6 nm, the nitride film is homogeneously formed over the entire surface. The MIS capacitor with a 5.4-nm-thick nitride film formed by radical nitrogen shows low hysteresis of less than 0.1 V and low leakage current density. These electrical properties indicate that the nitride films formed by radical nitrogen are applicable to gate insulators.
8 February 1988 in Applied Physics Letters
Effects of fluorine ion implantation on electrical characteristics of metal‐oxide‐semiconductor (MOS) devices on silicon‐on‐sapphire have been investigated. The fluorine implantation generates deep acceptor levels, the nature of which is significantly affected by the sequence of the implantation and gate oxidation in device fabrication process steps. It was found that drain leakage current of fluorine‐implanted MOStransistors can be reduced to about 0.1 times compared with unimplanted devices without degrading the basic electrical characteristics.