22 November 2021 in IEEE Transactions on Communications
The performance of Simultaneous Wireless Information and Power Transfer (SWIPT) is mainly constrained by the received Radio-Frequency (RF) signal strength. To tackle this problem, we introduce an Intelligent Reflecting Surface (IRS) to compensate the propagation loss and boost the transmission efficiency. This paper proposes a novel IRS-aided SWIPT system where a multi-carrier multi-antenna Access Point (AP) transmits information and power simultaneously, with the assist of an IRS, to a single-antenna User Equipment (UE) employing practical receiving schemes. Considering harvester nonlinearity, we characterize the achievable Rate-Energy (R-E) region through a joint optimization of waveform, active and passive beamforming based on the Channel State Information at the Transmitter (CSIT). This problem is solved by the Block Coordinate Descent (BCD) method, where we obtain the active precoder in closed form, the passive beamforming by the Successive Convex Approximation (SCA) approach, and the waveform amplitude by the Geometric Programming (GP) technique. To facilitate practical implementation, we also propose a low-complexity design based on closed-form adaptive waveform schemes. Simulation results demonstrate the proposed algorithms bring considerable R-E gains with robustness to CSIT inaccuracy and finite IRS states, and emphasize the importance of modeling harvester nonlinearity in the IRS-aided SWIPT design.
10 January 2022 in IEEE Transactions on Wireless Communications
In this paper, we study the waveform and passive beamforming design for intelligent reflecting surface (IRS)-aided wireless power transfer (WPT). Generalized multi-user and low complexity single-user algorithms are demonstrated based on alternating optimization (AO) framework to maximize the weighted sum output direct current (DC), subject to the transmit power constraints and passive beamforming modulus constraints. The input signal waveform and IRS passive beamforming phase shifts are jointly designed as a function of users’ individual frequency-selective channel state information (CSI). The energy harvester nonlinearity is explored and two IRS deployment schemes, namely frequency selective IRS (FS-IRS) and frequency flat IRS (FF-IRS), are modeled and analyzed. This paper highlights the fact that IRS can provide an extra passive beamforming gain on output DC power over conventional WPT designs and significantly influence the waveform design by leveraging the benefit of passive beamforming, frequency diversity and energy harvester nonlinearity. Even though FF-IRS exhibits lower output DC than the ideal FS-IRS, it still achieves substantially increased DC power over conventional WPT designs. Performance evaluations confirm the significant benefits of a joint waveform and passive beamforming design accounting for the energy harvester nonlinearity to boost the performance of single-user and multi-user WPT systems.
16 January 2023 in Fuel Processing Technology
15 April 2024 in IEEE Journal on Selected Areas in Communications
Backscatter Communication (BackCom) nodes harvest energy from and modulate information over external carriers. Reconfigurable Intelligent Surface (RIS) adapts phase shift response to alter channel strength in specific directions. In this paper, we unify those two seemingly different technologies (and their derivatives) into one architecture called RIScatter. RIScatter is a batteryless cognitive radio that recycles ambient signal in an adaptive and customizable manner, where dispersed or co-located scatter nodes partially modulate their information and partially engineer the wireless channel. The key is to render the probability distribution of reflection states as a joint function of the information source, Channel State Information (CSI), and relative priority of coexisting links. This enables RIScatter to softly bridge BackCom and RIS; reduce to either in special cases; or evolve in a mixed form for heterogeneous traffic control and universal hardware design. We also propose a low-complexity Successive Interference Cancellation (SIC)-free receiver that exploits the properties of RIScatter. For a single-user multi-node network, we characterize the achievable primary-(total-)backscatter rate region by optimizing the input distribution at scatter nodes, the active beamforming at the Access Point (AP), and the energy decision regions at the user. Simulations demonstrate RIScatter nodes can shift between backscatter modulation and passive beamforming.
18 September 2025 in IEEE Transactions on Signal Processing
This paper investigates the limits to which a passive Reconfigurable Intelligent Surface (RIS) can reshape a point-topoint Multiple-Input Multiple-Output (MIMO) channel in terms of singular values and their functions (e.g., achievable rate and harvestable power) for improved wireless performance. We depart from the Diagonal (D) scattering model and adopt a Beyond-Diagonal (BD) model that exploits element-wise connections for passive signal amplitude and phase manipulation. Specifically, analytical tight bounds are derived under typical RIS deployment scenarios to unveil the channel shaping potentials of BD-RIS regarding communication Degrees of Freedom (DoF), singular value spread, power gain, and capacity. An efficient numerical method is then proposed to optimize BD-RIS for any locally Lipschitz function of channel singular values, and showcased to characterize the achievable singular value region. As a side product, we tackle BD-RIS-aided MIMO rate maximization problem by a local-optimal Alternating Optimization (AO) approach and a low-complexity shaping approach. Results show that BD-RIS significantly improves the dynamic range of channel singular values and the tradeoff in manipulating them, thus offering enhanced data rate, harvestable power, and physical-layer security. These advantages become more pronounced when the number of RIS elements, group size, or MIMO dimensions increase. Of particular interest, BD-RIS is shown to activate multi-stream transmission and achieve the asymptotic DoF at much lower transmit power than D-RIS thanks to its proficiency in channel shaping.