4 September 2004 in Chemical Reviews
12 October 2022 in Nature
1 January 2000 in Journal of the Electrochemical Society
A transient, multidimensional model has been developed to simulate proton exchange membrane fuel cells. The model accounts simultaneously for electrochemical kinetics, current distribution, hydrodynamics, and multicomponent transport. A single set of conservation equations valid for flow channels, gas‐diffusion electrodes, catalyst layers, and the membrane region are developed and numerically solved using a finite‐volume‐based computational fluid dynamics technique. The numerical model is validated against published experimental data with good agreement. Subsequently, the model is applied to explore hydrogen dilution effects in the anode feed. The predicted polarization curves under hydrogen dilution conditions are in qualitative agreement with recent experiments reported in the literature. The detailed two‐dimensional electrochemical and flow/transport simulations further reveal that in the presence of hydrogen dilution in the fuel stream, hydrogen is depleted at the reaction surface, resulting in substantial anode mass transport polarization and hence a lower current density that is limited by hydrogen transport from the fuel stream to the reaction site. Finally, a transient simulation of the cell current density response to a step change in cell voltage is reported. © 2000 The Electrochemical Society. All rights reserved.
18 January 2021 in Nature Energy
24 May 2012 in Journal of the American Chemical Society
1 January 2006 in Journal of the Electrochemical Society
Liquid water transport and removal from the gas diffusion layer (GDL) and gas channel of a polymer electrolyte fuel cell (PEFC) are studied experimentally and theoretically. In situ observations of the liquid water distribution on the GDL surface and inside the gas channel were made in an operating transparent PEFC. Liquid droplet formation and emergence from the GDL surface are characterized and two modes of liquid water removal from the GDL surface identified: one through droplet detachment by the shear force of the core gas flow followed by a mist flow in the gas channel, and the other by capillary wicking onto the more hydrophilic channel walls followed by the annular film flow and/or liquid slug flow in the channel. In the former regime, typical of high gas flow rates, the droplet detachment diameter is correlated well with the mean gas velocity in the channel. In the latter regime characteristic of low gas flow rates, liquid spreading over hydrophilic channel surfaces and drainage via corner flow were observed and analyzed. A theory is developed to determine what operating parameters and channel surface contact angles lead to sufficient liquid drainage from the fuel cell via corner flow. Under these conditions, the fuel cell could operate stably under a low flow rate (or stoichiometry) with only a minimum pressure drop required to drive the oxidizer flow. However, when the corner flow is insufficient to remove liquid water from the gas channel, it was observed that the annular film flow occurs, often followed by film instability and channel clogging. Channel clogging shuts down an entire channel and hence reduces the cell’s active area and overall performance.