For a team of robots to work collaboratively, it is crucial that each robot have the ability to determine the position of their neighbors, relative to themselves, in order to execute tasks autonomously. This letter presents an algorithm for determining the three-dimensional relative position between two mobile robots, each using nothing more than a single ultra-wideband transceiver, an accelerometer, a rate gyro, and a magnetometer. A sliding window filter estimates the relative position at selected keypoints by combining the distance measurements with acceleration estimates, which each agent computes using an on-board attitude estimator. The algorithm is appropriate for real-time implementation, and has been tested in simulation and experiment, where it comfortably outperforms standard estimators. A positioning accuracy of less than 1 m is achieved with inexpensive sensors.
This paper presents a complete case study - named ROSACE for Research Open-Source Avionics and Control Engineering - that goes from a baseline flight controller, developed in MATLAB/SIMULINK, to a multi-periodic controller executing on a multi/many-core target. The interactions between control and computer engineers are highlighted during the development steps, in particular by investigating several multi-periodic configurations. We deduced ways to improve the discussion between engineers in order to ease the integration on the target. The whole case study is made available to the community under an open-source license.
1 September 2017 in Journal of Guidance, Control, and Dynamics
In recent years, multicopter unmanned aerial vehicles (UAV) have been widely used in many commercial and military applications. Due to the increasing requirement for high autonomy and safety, UAVs should possess a fault-tolerant ability to accommodate malfunctions during flight. This article presents two fault-tolerant control (FTC) designs for a mul-ticopter UAV subject to actuator faults. The proposed FTC approach is based on gain-scheduling control in the framework of structured H∞ synthesis. The scheduled gains of the first controller are parameterized as polynomial functions of the loss of actuator effectiveness, given by an appropriate fault detection and diagnosis system. In order to facilitate the tuning process, the second controller uses the loss of virtual control effectiveness as the gain-scheduling variable. Experimental results performed on an hexacopter UAV show the effectiveness and the robustness of these methods subject to multiple critical actuator faults.
This article deals with the stationary flight control problem of an Unmanned Aircraft Vehicle (UAV) flying in a wind field. The main objective is to develop a robust control law to stabilize the drone flying under real-life outdoor conditions while maintaining adequate flight performances. To do so, a generic nonlinear dynamic model of the quadcopter is firstly developed; this model is then completed with the modeling of the wind disturbances, which allows the simulation of the proposed control algorithms. Two approaches for the synthesis of the control laws are compared: the first one uses Linear Quadratic Regulator (LQR) synthesis and the second one uses structured H ∞ synthesis. Simulations are conducted to evaluate the performances of both control laws when subjected to a nominal wind step input varying from 0 to 14 m/s. This particular input choice makes it possible to analyze the performance of the controllers in both transient (wind gust) and steady states (sustained wind). The results show that better performances are obtained with the structured H ∞ synthesis using the robust control theory than with the LQR synthesis using the optimal control theory. Furthermore, it is shown that the simplicity of use of the Robust Control Toolbox of MATLAB favors the usage of more complex control architectures without impacting the workload of the control engineer.