30 August 2024 in The European Physical Journal Special Topics
Silica gels have a multitude of applications ranging from cosmetics and food science to oil and gas recovery. For proper design and application, it is important to have a thorough understanding of the underlying mechanisms of gel formation under different circumstances. The growth and structure of colloidal silica gels has been investigated using RheoSAXS to study the effect of silica concentration, NaCl concentration, temperature and shear rate. Additionally, SAXS in combination with a strong magnetic field has been applied to investigate the effect of magnetic microparticles and magnetic field on the development of the gel structure. Results indicate that the strongest effect on the gel kinetics are achieved by altering the activator concentration, here in the form of NaCl, followed by silica concentration and temperature. Small structural effects were also observed, with larger cluster sizes being produced at lower silica concentration and at higher NaCl concentration. Applying shear caused major changes both in structure as well as the macroscopic behavior of the silica, preventing the gel from reaching an arrested state, instead forming a viscous liquid. Applying a magnetic field appears to suppress the formation of larger clusters. The same effect is observed for increasing magnetic microparticle concentrations. Graphical Abstract
18 June 2026 in SSRN Electronic Journal
High adsorption capacity, selectivity, long term applicability and economic justification are some of the necessary requirements of a good CO2 adsorbent. Clay minerals may be a viable alternative in this regard as they are abundant, environmentally friendly and have been shown to adsorb CO2 under specific conditions. Using Powder X-ray diffraction, thermogravimetric analysis and adsorption isotherm measurements, we have investigated the CO2 adsorption of Nickel exchanged Wyoming montmorillonite (SWy-2) and a bentonite sample. Results indicate a partial intercalation of nickel in both samples, showing increased anhydrous d-spacing compared to the pristine samples. Both samples also displayed adsorption of CO2, however the nickel-bentonite samples was incompletely dehydrated and the uptake can thus not be directly attributed to the intercalation of nickel. CO2 uptakes of 0.48 mmol/g and 0.91 mmol/g at 50 bar 25°C were measured for the Ni-SWy-2 and Ni-Bent respectively. The results are consistent with previous findings in nickel exchanged fluorohectorite, where the anhydrous uptake has been attributed to the existence of nickel hydroxide islands. The anhydrous CO2 uptake in the Ni-SWy-2 sample is likely due to the same mechanism, however further investigations are necessary to unambiguously prove this.