Pile scour is the main cause of bridge failure. A physical model used in this research to study scour around a group of piles in clear-water conditions. The study examined changes in stream bed, volume and area of scour holes due to changes in pile spacing and arrangements. For this purpose, width, length and depth of scour hole variation and also changes in channel bed formation owing to pile groups, their arrangement and spacing were studied. An experimental channel with a length of 10 m, a width of 0.83 m and a depth of 0.5 m was used. The channel bed was covered with medium-sized uniform sediments for 0.9 mm. The discharge and flow velocity were adjusted to clear-water conditions. In each experiment, the channel bed changes and the scour hole were recorded and analysed. The results showed that the piles’ arrangement and their spacing affected the area and volume of scour hole so that with increasing pile spacing, despite the scour depth, volume and area of the scour hole increased. The channel bed formation and movement of sedimentation areas and scour was also affected by the arrangement and spacing of piles. The results of this study can be used by engineers to optimize the design of bridges and determine the zones around piles for scour protection.
1 January 2014 in Journal of the Geological Society of India
Numerical simulation of groundwater flow used for the estimation of hydraulic and hydrologic parameters which is an important tool for the management of aquifers. This study presents the results of a mathematical model developed for the simulation of groundwater flow in Nahavand plain aquifer in the southwest Hamadan province. For this purpose Groundwater Modeling Software (GMS) was used which supports the MODFLOW-2000 code. After gathering required data such as the hydrological, hydrogeological and topography maps, a 3D hydrogeological model of plain was constructed with borehole and surface elevation data. Then MODFLOW was used for simulation of flow. After initial simulation of the flow, the model was calibrated in steady state with trial-and-error and parameter estimation methods the observed head of groundwater table monitoring data of 1997. Results of calibration show that error between observed head and computed head is in allowable range. Also results of computed head with model show that groundwater flow is in the direction of the dominate slope (southeast to northwest). Finally MODPATH code which simulates advective transport of particles was used for estimation of flow path and source of contaminants.
The study of heavy metals’ redistribution between different fractions allows to know their bioavailability and mobility in soils. Soil samples were collected from a lead mine in Hamadan provinces, NW Iran. In a factorial experiment soil was treated with cow, sheep and poultry manures (20 g kg−1 soil) separately and incubated near field capacity at 10°C and 37°C. An untreated soil (as control) was also incubated at the same temperatures. After 0 and 120 days, a sequential extraction scheme was used to fractionate Pb of incubated samples into soluble-exchangeable (Sol-Exch), organic matter associated (AOM), carbonates associated (ACar), and residual (Res) forms. Soil Pb in Sol-Exch and AOM fractions were increased by manure application significantly. The AOM and ACar forms of Pb were higher in soils treated with the manures and incubated in lower temperature. In contrast, the Sol-Exch and Res chemical forms of Pb were higher in the soils incubated at 37°C. These results may be related to the higher calcium carbonate dissolution and organic matter decomposition because of better biological activity in the soils incubated in higher temperature. The increase of the Res fraction (stable form) in this condition may resulted in lower toxicity and mobility in soil environment.