Electric vehicle battery electrodes are delaminated ultra-fast using high-powered ultrasound, separating active materials from the foil current collectors.
Ultrasonic delamination is a low energy approach for direct recycling of spent lithium-ion batteries. The efficiency of the ultrasonic delamination relies both on the thermophysical properties (such as viscosity, surface tension, and vapour pressure) of the solvent in which the delamination process is carried out, and the properties of the ultrasound source as well as the geometry of the containment vessel. However, the effect of tailoring solutions to optimise cavitation and delamination of battery cathode coatings has not yet been sufficiently investigated. Acoustic detection, high-speed imaging, and sonochemiluminescence (SCL) are employed to study the cavitation processes in water-glycol systems and identify the effect of tailoring solvent composition on cavitation strength. The addition of small volume fractions of organic solvent (ca. 10-30 vol%), including ethylene glycol or glycerol, to the aqueous delamination solution were found to significantly improve the delamination efficiency of lithium-ion battery cathode coatings due to the alteration of these thermophysical properties. However, greater volume fractions of glycol decrease delamination efficiency due to the signal-dampening effect of viscosity on the ultrasonic waves. The findings of this study offer valuable insights for optimising ultrasonic bath solution composition to enhance film delamination processes.
2 February 2024 in The Journal of Physical Chemistry C
With various battery directives necessitating the composition of recycled electrode materials this study manufactures anodes containing various ratios of pristine and reclaimed graphite from end‐of‐life (EOL) cells. Two approaches that can be used to delaminate graphite are using ultrasonication (USD) and simple water delamination (WD). X‐ray micro‐computed tomography is used to characterize the graphite particles and show that particle fracturing is evident with both methods, but key structural metrics such as particle radius and diffusivity varied significantly. It is shown that blending 20% recovers material with 80% pristine graphite causes no statistically significant difference in the performance of the cells. This suggests that recycling anode materials can be achieved without significant post‐processing required. For WD anode material, the spherical graphite particles are maintained, whereas USD significantly changes the morphology and produces a large amount of “needle‐like” particles. Using 100% reclaimed anode material causes the performance of the cell to decrease to 279 mAh g−1 for WD material and 254 mAh g−1 for USD graphite. The use of “blended” electrodes using WD graphite and pristine material creates electrodes with a comparable Li+ flux and electrochemical performance to a pristine graphite reference of 300–315 mAh g−1.