Tecnológico de Monterrey. Escuela de Ingeniería y Ciencias. Campus Estado de México. Carretera Lago de Guadalupe km 3.5, Atizapán de Zaragoza. C.P. 52926. Estado de México, Mexico
Auto-generated profile, based on publicly available information
Cesar García Díaz
Tecnológico de Monterrey. Escuela de Ingeniería y Ciencias. Campus Estado de México. Carretera Lago de Guadalupe km 3.5, Atizapán de Zaragoza. C.P. 52926. Estado de México, Mexico
Mixing operations in biological processes is of utmost importance due to its effect on scaling-up and heat and mass transfer. This paper presents the characterization of a bench-top bioreactor with different impeller configurations, agitation and oxygen transfer rates, using CFD simulations and experimental procedures. Here, it is demonstrated that factors such as the type of impeller and the flow regime can drastically vary the operation as in the preparation of cultures. It was observed that the bioreactor equipped with a Rushton generates a of 0.0056 s−1 for an agitation velocity and airflow rate of 250 RPM and 5 L/min, respectively. It is suitable result for the dissolved oxygen (DO) but requires a considerable amount of power consumption. It is here where the importance of the agitator’s diameter can be observed, since, in the case of the two propeller types studied, lower energy consumption can be achieved with a smaller diameter, as well as a much smaller shear cup 2.376 against 0.723 s−1 by decreasing by 4 cm the standard diameter of an agitated tank (10 cm). Finally, the values obtained for the different configurations are compared with the maximum shear rate values of different cell cultures to highlight the impact of this study and its applicability to different industries that use agitation processes for cell growth.
Polycyclic aromatic hydrocarbons (PAHs) are hazardous compounds originating from anthropogenic activity. Due to their carcinogenic properties for humans, several technologies have been developed for PAH removal. Sorption with natural and organic materials is currently one of the most studied due to its low cost and its environmentally friendly nature. In this work, a hybrid sorbent involving functionalized humic acids (HAs) and nano-zeolite is proposed to entrap PAHs. The use of functionalized HAs immobilized in a porous support is designed to address the instability of HAs in solution, which has been already reported. HA functionalization was carried out to increase the non-polarity of HAs and aliphatic group formation. The HAs were functionalized by esterification/etherification with alkyl halides, and their chemical changes were verified by FTIR and NMR. The sorption isotherms of the functionalized HAs in micro- and nano-zeolites were used to assess the performance of the nano-zeolites in adsorbing these HAs. The hybrid support allowed the removal of anthracene and pyrene at percentages higher than 90%; fluoranthene, of angular molecular structure, was adsorbed at 85%. PAHs are ubiquitous in the environment, and a stable sorption of them in solid matrices will allow their removal from the environment through effective and environmentally friendly methods.