13 September 2019 in Journal of Adhesion Science and Technology
In this study, several mechanistic models for particle removal from substrates were introduced and their predictive ability was tested. Empirically optimized parameters for a selected set of particle-substrate combinations were obtained and the ability of these models to predict resuspension for a large number of particle-substrate combinations and flow conditions using the published experimental data was explored. Our analysis showed that accurate predictions for a broad spectrum of particle-substrate combinations require accounting for substrate roughness and particle non-sphericity. From analysis of our compiled experimental data set, it was determined that the shear velocities required for particle resuspension follow a log-normal distribution, with geometric standard deviations in the range of 1.4 to 1.7. From comparison of the calculated and measured critical shear velocities, we found that a critical roughness parameter value of Δc = 0.774 is a reasonable estimate for most real substrates. We show that the combination of parameters determined from our study and models that account for roughness and particle non-sphericity, it is possible to predict particle resuspension from most substrates with reasonable accuracy.
2 December 2019 in Aerosol Science and Technology
The resuspension rate of particles from surfaces is significantly dependent on surface roughness. Existing models only consider the case of surface asperities much smaller than particle diameter, but often particle sizes of interest are comparable or smaller than substrate roughness. In this study, a model for particle removal from large-scale roughness is described. Substrate roughness is described using a 2D sinusoidal profile. The critical shear velocity is determined considering rolling detachment of particles with JKR adhesion model and hydrodynamic moments on particles residing on the rough substrates. Our model results show that the effect of surface roughness on critical shear velocity is strongly dependent on the value of roughness amplitude and wavelength relative to particle size. The model predicts four primary removal regions based on relative particle-surface characteristics: easier-to-remove than smooth substrate, more difficult to remove than smooth substrate, not possible to remove, and similar behavior as smooth surface. The model performance is validated by comparison of predictions with published experimental results for highly rough substrates.