16 November 2018 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
This article addresses the yaw stability of articulated vehicles by assessing the influence of the road-tire friction coefficient on the convergence region of a particular equilibrium condition. In addition, the boundaries of this region are compared to the boundaries of the non-jackknife and non-rollover regions to distinguish the instability phenomenon, jackknife or roll-over, responsible for this delimitation. The vehicle configuration considered in this analysis is composed by one tractor unit and one towed unit connected through an articulation point, for instance, a tractor-semitrailer combination. A nonlinear articulated bicycle model with four degrees of freedom is used together with a nonlinear lateral force tire model. To estimate the convergence region, the phase trajectory method is used. The equations of motion of the mathematical model are numerically integrated for different initial conditions in the phase plane, and the state orbits are monitored in order to verify the convergence point and the occurrence of instability events. In all cases, the longitudinal force on each tire, such as traction and braking, is not considered. The results show the existence of convergence regions delimited only by jackknife events, for low values of the friction coefficient, and only by rollover events, for high values of the friction coefficient. Moreover, the transition between these two conditions as the friction coefficient is changed is graphically presented. The main contributions of this article are the identification of the abrupt reduction of the convergence region as the value of the friction coefficient increases and the distinction of the instability events, jackknife or rollover, that define the boundaries of the convergence region.
2 September 2022 in Proceedings of the Institution of Mechanical Engineers, Part M: Journal of Engineering for the Maritime Environment
Remotely Operated Vehicles (ROVs) working close to the sea surface are subjected to wave disturbances that affect their positioning. To treat this problem, we present a control scheme for the dynamic positioning of ROVs under wave disturbances and at low operation depths. The approach is composed of an Augmented Wave Filter (AWF) based on the Extended Kalman Filter (EKF) algorithm and an Adaptive-Model Predictive Control (A-MPC). The filter provides the optimal motion states and wave height estimation to the A-MPC, which calculates the control efforts based on the receding horizon approach. The scheme is tested through numerical simulations on the depth control of the Mandi II-ROV at the diving plane. The results are compared to those of a standard Proportional-Integral-Derivative (PID) controller. To perform realistic simulations, a detailed mathematical model is presented, considering the rigid body-motion, hydrodynamic and hydrostatic forces, thrusters dynamics, and onboard sensor measurements. The simulations are performed for different scenarios, considering the dynamic positioning in still waters and the station-keeping under wave disturbances for significant heights of 1 and 2 m. The controller robustness to parameter variation is assessed by using Monte-Carlo simulation. Results have shown improved performance for the A-MPC in terms of positioning errors, motion oscillations, and drift attenuation in comparison to a PID controller. The Monte-Carlo simulation reveals enhanced robustness to the A-MPC, which is associated with the greater variance for the control forces. Also, the filter performed very well in all the tests, producing an accurate estimate of the wave-induced height and providing an off-set free control.
7 November 2017 in Expert Systems
28 July 2020 in Brazilian Journal of Chemical Engineering
23 May 2020 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
1 March 2025 in Journal of the Brazilian Society of Mechanical Sciences and Engineering