3 February 2020 in Optica
The effect of spatial hole burning on mode proliferation has been shown both theoretically and experimentally to be important for frequency comb operation in quantum cascade lasers (QCLs). It is therefore of great interest to investigate the frequency comb operation from integrated ring cavities where this effect is absent. Here we report a mid-infrared quantum cascade laser based on a buried heterostructure ring cavity that exhibits unidirectional lasing with a frequency comb spectrum displaying a predominantly profile over a bandwidth of . A single beat note with 3 dB linewidth of was observed over the last 85% of the whole current dynamic range. To further verify the frequency comb operation, a multiheterodyne experiment was carried out using a standard Fabry–Pérot QCL comb as a reference laser. This measurement allowed the retrieval of the spectral phases, indicating an operation with strong amplitude modulation.
11 November 2021 in Laser & Photonics Reviews
In this work, control over the precise state emitted by quantum cascade laser frequency combs through strong radio‐frequency current modulation close to their repetition frequency is demonstrated. In particular, broadening of the spectrum from about 20 cm−1 to an average bandwidth of 60 cm−1 can be achieved throughout most of the current dynamical range while preserving the coherence, as measured by shifted wave interference Fourier transform spectroscopy (SWIFTS). The required modulation frequency to achieve this broadening is red‐shifted compared to the free‐running beatnote frequency at increasing modulation powers starting from 25 dBm, whereas the range where it occurs narrows. Outside of this maximum‐bandwidth range, the spectral bandwidth of the laser output is gradually reduced and the new center frequency is red‐ or blue‐shifted, directly dependent on the detuning of the modulation frequency. By switching between two modulation frequencies detuned symmetrically with respect to the free‐running beatnote, two multiplexed spectral regions with negligible overlap from the same device at rates of at least 20 kHz can be generated. In the time‐domain, with both SWIFTS and interferometric autocorrelation (IAC) measurements a transition from quasi‐continuous output to long‐pulsed ( ps) output is shown by ramping up the injection power to 35 dBm.
15 February 2021 in Applied Physics Letters
In this work, a design for a mid-infrared quantum cascade laser frequency comb source that enhances the high frequency response and the comb characteristics of the device is presented. A state-of-the-art active region, grown on a heavily n-doped InP:Si substrate, was processed into a buried heterostructure with a microstrip-like line waveguide. As a result, the repetition rate frequency frep, around 11.09 GHz, can be locked to an injected narrow-linewidth radio frequency (RF) signal, over a range of more than 200 kHz with an injected power of −10 dBm, which outperforms normal buried heterostructure schemes by an order of magnitude. Moreover, under RF injection at powers higher than 20 dBm, the lasing spectrum is flattened and significantly broadened, from 24 to 65 in bandwidth, while at the same time, the coherence of the comb is maintained and verified.
29 May 2019 in Journal of the Optical Society of America B
A Martinez-type stretcher-compressor is used to modify the spectral phases of a high-power () quantum cascade laser (QCL) comb emitted at 8.2 μm with more than spectral bandwidth. Using this scheme, we demonstrate a compression of the QCL output from a 134 ps continuous-wave waveform, to a train of pulses of width 12 ps, and a power with peak to average ratio of 40.7. An evaluation of the phase noise of the free-running device yields an integrated timing jitter of 335 fs over the frequency range 20 kHz–100 MHz, and a pulse-to-pulse jitter of 2.0 fs.
24 August 2018 in Optics Express
Quantum cascade lasers are proving to be instrumental in the development of compact frequency comb sources at mid-infrared and terahertz frequencies. Here we demonstrate a heterogeneous terahertz quantum cascade laser with two active regions spaced exactly by one octave. Both active regions are based on a four-quantum well laser design and they emit a combined 3 mW peak power at 15 K in pulsed mode. The two central frequencies are 2.3 THz (bandwidth 300 GHz) and 4.6 THz (bandwidth 270 GHz). The structure is engineered in a way that allows simultaneous operation of the two active regions in the comb regime, serving as a double comb source as well as a test bench structure for all waveguide internal self-referencing techniques. Narrow RF beatnotes (∼ 15 kHz) are recorded showing the simultaneous operation of the two combs, whose free-running coherence properties are investigated by means of beatnote spectroscopy performed both with an external detector and via self-mixing. Comb operation in a highly dispersive region (4.6 THz) relying only on gain bandwidth engineering shows the potential for broad spectral coverage with compact comb sources.