On August 17, 1999, a destructive earthquake occurred in the western part of the North Anatolian Fault Zone, Turkey. The earthquake source region has been designated as a seismic gap and an M7-class earthquake has been supposed to occur someday in the future so as to fill this seismic gap. So far we have undertaken various kinds of observations in this area and we could obtain some valuable data before, during and after the mainshock. Here we report some of the preliminary results of our recent studies, which include field work started in late July this year and continued during and after the earthquake occurrence just in the earthquake source region and its vicinity, in addition to seismic observations carried out for several years before the mainshock. Much emphasis is put on magnetotelluric field data acquired during the mainshock; in fact, large variations caused by seismic waves were recorded. Such variations could be interpreted in terms of electromagnetic induction in the conducting crust caused by the velocity field interacting with the static magnetic field of the Earth. In particular, the first motion of seismic wave could be identified in the records and used for precise determination of the hypocenter of the mainshock.
On 29 June 2015, a small phreatic eruption occurred at Hakone volcano, Central Japan, forming several vents in the Owakudani geothermal area on the northern slope of the central cones. Intense earthquake swarm activity and geodetic signals corresponding to the 2015 eruption were also observed within the Hakone caldera. To complement these observations and to characterise the shallow resistivity structure of Hakone caldera, we carried out a three-dimensional inversion of magnetotelluric measurement data acquired at 64 sites across the region. We utilised an unstructured tetrahedral mesh for the inversion code of the edge-based finite element method to account for the steep topography of the region during the inversion process. The main features of the best-fit three-dimensional model are a bell-shaped conductor, the bottom of which shows good agreement with the upper limit of seismicity, beneath the central cones and the Owakudani geothermal area, and several buried bowl-shaped conductive zones beneath the Gora and Kojiri areas. We infer that the main bell-shaped conductor represents a hydrothermally altered zone that acts as a cap or seal to resist the upwelling of volcanic fluids. Enhanced volcanic activity may cause volcanic fluids to pass through the resistive body surrounded by the altered zone and thus promote brittle failure within the resistive body. The overlapping locations of the bowl-shaped conductors, the buried caldera structures and the presence of sodium-chloride-rich hot springs indicate that the conductors represent porous media saturated by high-salinity hot spring waters. The linear clusters of earthquake swarms beneath the Kojiri area may indicate several weak zones that formed due to these structural contrasts.
We obtained an electrical transect image of the Niigata‐Kobe Tectonic Zone (NKTZ). Several major active faults are located in this zone of concentrated deformation. The main features of the final two‐dimensional model are a thick resistive block in the upper crust, with a thinned‐out portion beneath the Atotsugawa Fault, and a strong conductor in the lower crust that intrudes upward into the upper resistor. The upper crustal resistive zone corresponds well to the spatiality of the NKTZ, and relatively conductive zones sandwiching this resistor may contribute to observed changes in displacement rates. The overlapping locations of the conductor and the low‐velocity body in the lower crust indicate that the conductor represents a zone that was weakened by fluids. Given that microearthquakes are localized in the regions between the resistive and conductive zones, we suggest that the distribution of earthquakes is influenced by intrusions of fluid derived from the conductor.
Crustal earthquake ruptures tend to initiate near fluid-rich zones. However, it is relatively unknown whether fluid-rich zones can further promote or arrest these ruptures. We image the electrical resistivity structure around the focal area of the 2016 Kumamoto earthquake sequence by using 200 sites broadband magnetotelluric data, and discuss its quantitative relationship to earthquake initiation, growth, and arrest processes. The ruptures that initiated along the outer edge of the low-resistivity fluid-rich zones (< 30 Ωm) tended to become large earthquakes, whereas those that initiated either distal to or within the fluid-rich zones did not. The ruptures were arrested by high-temperature (> 400 °C) fluid-rich zones, whereas shallower low-temperature (200–400 °C) fluid-rich zones either promoted or arrested the ruptures. These results suggest that the distribution of mid-crustal fluids contributes to the initiation, growth, and arrest of crustal earthquakes. The pre-failure pressure/temperature gradient (spatial difference) of the pore fluids may contribute to the rupture initiation, propagation, and arrest.