1 January 2007 in Engineering Geology
17 November 2009 in Environmental Earth Sciences
7 April 2011 in Natural Hazards and Earth System Sciences
Liquefaction is one of the critical problems in geotechnical engineering. High ground water levels and alluvial soils have a high potential risk for damage due to liquefaction, especially in seismically active regions. Eskişehir urban area, studied in this article, is situated within the second degree earthquake region on the seismic hazard zonation map of Turkey and is surrounded by Eskişehir, North Anatolian, Kütahya and Simav Fault Zones. Geotechnical investigations are carried out in two stages: field and laboratory. In the first stage, 232 boreholes in different locations were drilled and Standard Penetration Test (SPT) was performed. Test pits at 106 different locations were also excavated to support geotechnical data obtained from field tests. In the second stage, experimental studies were performed to determine the Atterberg limits and physical properties of soils. Liquefaction potential was investigated by a simplified method based on SPT. A scenario earthquake of magnitude M=6.4, produced by Eskişehir Fault Zone, was used in the calculations. Analyses were carried out for PGA levels at 0.19, 0.30 and 0.47 g. The results of the analyses indicate that presence of high ground water level and alluvial soil increase the liquefaction potential with the seismic features of the region. Following the analyses, liquefaction potential maps were produced for different depth intervals and can be used effectively for development plans and risk management practices in Eskişehir.
19 October 2007 in Natural Hazards and Earth System Sciences
The city of Eskişehir in inner-western Turkey has experienced a destructive earthquake with Ms=6.4 in 1956 in addition to many events with magnitudes greater than 5. It is located in a wide basin having young sedimentary units and thick alluvium soils which also include liquefiable sand materials. There is also an active fault passing beneath the city center and the groundwater level is very close to the ground surface. Approximately 600 thousand people are living in the province of Eskişehir. Therefore, the city and its vicinity have a high risk, when earthquake hazard is considered. This paper summarizes the probabilistic seismic hazard analysis (PSHA) which was performed for the province of Eskişehir and introduces seismic hazard maps produced by considering earthquakes with magnitude Ms≥4.0 occurred during the last 100-years and a seismic model composed of four seismic sources. The results of PSHA show that the average peak ground acceleration (PGA) for the city center is 0.40 g for 10 percent probability of exceedance in 50 years, for rock site. The seismic hazard maps were obtained by means of a program of Geographic Information System.
18 January 2013 in Natural Hazards and Earth System Sciences
Limited knowledge of ground conditions, such as geotechnical parameters, is one of the main causes of foundation failure. Unknown ground conditions can also cause additional burden costs. Due to lack of geotechnical parameters in foundation soil, some problems can be observed during and after the construction. In this study, a comprehensive field study was conducted to make a preliminary hazard assessment on the Meşelik campus area, Eskişehir, Turkey. In this context, the experimental studies were performed in two stages. In the first stage, boreholes were drilled in the field; a standard penetration test (SPT) was performed and disturbed/undisturbed samples were collected from certain levels. In the second stage, laboratory tests were performed in order to identify and classify the samples. Unconfined compression strength and triaxial compression tests were conducted on undisturbed samples for determining the engineering characteristics. XRD (X-ray diffraction) tests were performed and the swelling potential of the samples were evaluated. The liquefaction potential of the area was also assessed on a SPT-based method. Thus, the geotechnical parameters and the liquefaction potential of the sub-surface in the study area were thoroughly analyzed and presented to be used for further studies.
23 June 2023 in Jeoloji Mühendisliği Dergisi
Bu çalışma kapsamında Kayseri – Soğanlı yerleşim yerinde meydana gelebilecek kaya düşmeleri ampirik olarak enerji açısı yöntemiyle ve 3-boyutlu olasılıksal kaya düşme modellemeleri ile değerlendirilmiştir. Yüksek çözünürlüklü sayısal yüzey modeli (SYM) insansız hava aracı (İHA) ile elde edilen yüksek çözünürlüklü ortofoto yardımıyla elde edilmiştir. SYM üzerinde 3-boyutlu olasılıksal kaya düşme simülasyonları, CONEFALL yazılımı yardımıyla enerji çizgi açısı yöntemine göre kaya düşme zonları belirlenerek gerçekleştirilmiştir. Geçmişte düşmüş olan kaya blokların en, boy ve yükseklikleri arazi çalışmaları ve İHA ile oluşturulan ortofoto üzerinden belirlenmiştir. 3-boyutlu olasılıksal analizler neticesinde 3 m’lik kaya bloklarının yamaç boyunca hareketi esnasında kinetik enerji değerleri maksimum 15,000 kJ, sıçrama yüksekliği ise 15 m olarak belirlenmiştir. Enerji çizgi açısı yöntemi dikkate alındığında, incelenen yamacın güney kesiminde daha önceden düşen blokların çoğunlukla 40°’lik enerji çizgi açısı zonunda yoğunlaştığı tespit edilmiştir. Öte yandan, 3 m blok boyutu için yapılan olasılıksal 3-boyutlu kaya düşme analizlerinden elde edilen yuvarlanma hatları en fazla 30°’lik enerji çizgi açısı zonuna kadar ulaşsa da, özellikle yamacın güney kesiminde bu yuvarlanma hatları 40°’lik enerji çizgi açısı zonunda sonlanmaktadır. Buna göre, ampirik yöntem, 3-boyutlu olasılıksal yöntem ve arazide ölçülen blokların konumları genel olarak uyum göstermektedir.