7 December 2018 in Science
Working toward fluoride batteries: Owing to the low atomic weight of fluorine, rechargeable fluoride-based batteries could offer very high energy density. However, current batteries need to operate at high temperatures that are required for the molten salt electrolytes. Davis et al. push toward batteries that can operate at room temperature, through two advances. One is the development of a room-temperature liquid electrolyte based on a stable tetraalkylammonium salt–fluorinated ether combination. The second is a copper–lanthanum trifluoride core-shell cathode material that demonstrates reversible partial fluorination and defluorination reactions. Science , this issue p. 1144
16 October 2019 in Materials Chemistry Frontiers
Understanding the factors that influence ion-solvent properties for the fluoride ion in organic solvents is key to the development of useful liquid electrolytes for fluoride-ion batteries. Using both experimental and computational methods, we examined a range of chemical and electrochemical properties for a set of organic solvents in combination with dry N,N,N-trimethylneopentylammonium fluoride (Np1F) salt. Results showed that solvent electronic structure strongly influences Np1F dissolution, and the pKa of solvent protons provides a good guide to potential F− reactivity. We found a number of organic solvents capable of dissolving Np1F while providing chemically-stable F− in solution and characterized three of them in detail: propionitrile (PN), 2,6-difluoropyridine (2,6-DFP), and bis(2,2,2-trifluoroethyl) ether (BTFE). Arrhenius analysis for Np1F/PN, Np1F/DFP, and Np1F/BTFE electrolytes suggests that DFP facilitates the highest F− ion mobility of the three neat solvents. Electrolyte mixtures of BTFE and amide co-solvents exhibit higher ionic conductivity than the neat solvents. This improved ionic conductivity is attributed to the ability of BTFE:co-solvent mixtures to partition between Np1 + and F− ion-aggregates, promoting better ion dissociation.
11 October 2013 in Journal of Chemical Education
28 August 2015 in Journal of the Electrochemical Society
Li-rich layered-layered nickel manganese cobalt oxides (LLNMC) of the type Li2MnO3-LiMO2 (M = Mn, Co, Ni) are promising cathode materials due to their higher specific capacities and discharge voltages compared to state of art materials. However, these materials have yet to exhibit adequate cycle life and power characteristics in practical cells, partly due to the instability of electrolytes at these high voltages. Thin coatings of inorganic materials such as Al2O3, AlPO4, and AlF3 have been shown to minimize these degradation processes, especially on high voltage cathodes. Here, we report the use of a new aluminum borate-based coating material on the LLNMC cathode at high active mass loadings. AlBO3-coated cathodes demonstrate a sevenfold increase in lifetime compared to uncoated material, as well as higher specific discharge energies vs. analogous AlPO4-coated materials. SEM and TEM confirm the thin coatings of amorphous material. Detailed electrochemical studies including Tafel polarization, PITT, and Electrochemical Impedance Spectroscopy (EIS) show that the AlBO3 coating improves the kinetics of electron transfer.
22 May 2018 in The Journal of Physical Chemistry C
9 February 2015 in Synlett
The use of a gold-catalyzed, microwave protocol to activate alcohols through an intermolecular, SN1-type reaction to directly form unsymmetrical ethers and N-benzyloxy carbamate- (Cbz) protected amines is reported. Results have shown this reaction to be highly reproducible and tolerant of moisture, and moderate to high product yields (53–99%) were obtained. Significantly, the intermolecular catalytic amination of alcohols to directly afford Cbz-protected amines is heretofore unprecedented using gold catalysis.