1 May 2016 in Journal of Materials Processing Technology
1 April 2018 in Journal of Alloys and Compounds
1 August 2017 in Materials Science and Engineering: A
1 January 2017 in Advances in Materials Science and Engineering
AW-7xxx alloys have been nowadays considered for greater light weighting potential in automotive industry due to its higher strength compared to AW-5xxx and AW-6xxx alloys. However, due to their lower formability the forming processes are still in development. This paper investigates one such forming process called hot stamping. The investigation started by carrying out hot tensile testing of an AW-7xxx alloy, that is, AW-7921 at temperatures between 350°C and 475°C, to measure the strength and formability. Formability was found to improve with increasing temperature and was sensitive to the strain rate. Dynamic recovery is considered as usual reason for the formability improvement. However, examining the precipitation states of the as-received condition and after hot stamping using differential scanning calorimetry (DSC), the dissolution of precipitates was also believed to contribute to this increase in formability. Following solution heat treatment there was no precipitation during cooling across the cooling rates investigated (5–10°C/s). Samples taken from parts hot stamped at 10 and 20 mm s−1 had similar yield strengths. A 3-step paint baking heat treatment yielded a higher postpaint baking strength than a single step treatment.
20 June 2014 in Materials Science Forum
High formability is required to stamp aluminium into complex structural automotive components such as the A-pillar and B-pillar. Formability of an Al-Zn-Mg (AA7xxx) alloy sheet is characterised through hot stamping a prototype part and simulating paint baking procedures. The precipitation behaviour is assessed by differential scanning calorimetry and the tensile properties measured between 350°C and 475°C over a range of strain rates from 0.01s-1 to 1s-1. Natural ageing was found to increase the hardness of the hot stamped parts due to the formation of GP zone precipitates. A simulated three step paint baking procedure produced η precipitates and resulted in a yield strength and ultimate tensile strength of 480MPa and 512MPa, respectively.
10 July 2015 in Key Engineering Materials
In this paper, we have investigated AW-7921 in various tempers - specifically under aged T4P1-and T4P2-tempers, naturally aged T4 and peak-aged T6-tempers - for their warm formability at 230°C and paint baking response through one step and five step paint baking treatments. It was found that warm formability depends on dynamic recovery and dissolution of precipitates. However, the response to paint baking was dependent on the stability of the precipitates against coarsening. Of the tempers investigated the T4-temper exhibited the best combination of formability and paint baking response. This study also indicated that we can achieve much better performance in the warm forming processing chain by optimization of the temper and paint baking heat treatment procedure.