In this study, Ni-P/ZrO2 nanocomposite coatings were deposited on St-37 steel substrates using the electroplating method with varying ZrO2 concentrations and current densities. To investigate the effects of electrolyte components and current density on coating properties, analyses were performed regarding microhardness, wear performance, and surface morphology. As a result of the analyses, it is observed that different bath concentrations and current densities significantly affect properties such as morphology, hardness, and wear performance. It is seen that the surface morphologies of the obtained coatings are generally smooth, but it is understood from the optical images that the surfaces of all nanocomposite coatings are rougher. While adding ZrO2 nanoparticles to the main matrix increases microhardness by approximately 40% compared to pure nickel, a similar but higher hardness value was obtained with the increase in current density. When examined in terms of wear performance, an average friction coefficient value of 3.15 times higher than that of pure nickel nanocomposite coatings was obtained.
29 December 2025 in Cukurova University Journal of Natural and Applied Sciences
In order for copper parts, which are widely used in the industry, to exhibit better mechanical properties at low cost, electrodeposition is performed. In this context, the prominent nickel coatings are constantly being improved. The experiments carried out aimed to optimize the electrodeposition process by using reinforcement elements. Within the scope of our study, chromium, which attracts attention with its corrosion resistance and aesthetic appearance, was added to the structure of nickel coatings. In addition, Si3N4 ceramic particles, which have high thermal stability and high corrosion resistance, were added to the coating structure as the third phase reinforcement element. Coatings were carried out in a Watts type bath and abrasion test and surface roughness test were performed for the analysis of the samples. The test results showed that chromium added to the coating structure reduced the average friction coefficient from the value of 0.46 for pure nickel coatings to the value of 0.32 Si3N4 ceramic particles added to the coating structure together with chromium have a lower average friction coefficient than pure nickel coatings, while they have a higher average friction coefficient than Ni-Cr coatings. In addition, Si3N4 coatings added to the coating structure have an average wear rate of 3.2 times higher than Ni-Cr coatings.