A series of semi-interpenetrating polymer network anion exchange membranes (semi-IPN AEMs), composed of a quaternized poly(styrene) (PS) copolymer and crosslinked poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) networks, have been designed and fabricated. In this system, quaternized PS served as an anion transport moiety, while crosslinked PPO networks formed by azide–alkyne cycloaddition under an organic base were expected to maintain the mechanical properties and dimensional stability of the resulting semi-IPN AEMs. The semi-IPN AEMs showed improved mechanical properties compared to the control sample prepared by physical blending without crosslinking. It was found that the sIPN-62/30 AEM with an IEC of 1.44 meq. g−1 showed the highest hydroxide conductivity of 37.2 mS cm−1 at 20 °C and a relatively low swelling ratio of 12% at 20 °C in water. Further increasing the fraction of the linear conductive component (sIPN-75/20) led to a dramatic increase of water uptake, which diluted the ion concentration in the AEMs, consequently decreasing the hydroxide conductivity of the membrane (28 mS cm−1 at 20 °C). However, a high mechanical strength and low swelling ratio were observed for sIPN-75/20 samples due to the presence of hydrophobic crosslinked PPO networks. The alkaline stability of the semi-IPN AEMs was evaluated in 1 M NaOH at 80 °C. 59.1%, 86.7% and 74.8% retention in hydroxide conductivity, weight and IEC values were recorded for the sIPN-62/30 AEM respectively after 700 h testing. This result indicated that the crosslinked networks in semi-IPN AEMs can effectively protect the cations from being attacked by hydroxide ions. A single H2/O2 alkaline fuel cell of the sIPN-62/30 membrane demonstrated that a maximum power density of 110.6 mW cm−2 was achieved at a current density of 280 mA cm−2 at 60 °C. Although a loss of 78.3% of its initial performance was observed for the sIPN-62/30 membrane after 30 h alkaline fuel cell durability testing at 100 mA cm−2, high retention in IEC values and hydroxide conductivity for the aged sIPN-62/30 membrane shows that the semi-IPN AEMs based on BTMA cations are chemically stable under fuel cell operation conditions.
A facile and ultrasensitive fluorometric assay for trypsin detection was successfully established on the basis of surfactant/protamine/fluorescent hydrophobic dye assemblies. The supramolecular micellar-type assemblies were obtained by mixing the positively charged protein protamine as the substrate of trypsin with the anionic surfactant sodium dodecyl sulfate (SDS) at a level lower than its critical micelle concentration (CMC), and their apolar interiors could sequester several types of the representative hydrophobic fluorescent dyes such as Nile red, pyrene, and coumarin 6. It was found that the supramolecular assemblies exhibited a high specificity towards trypsin and its stability had a significant effect on the fluorescent intensity of the sequestered dyes. The addition of trypsin into the assembly system led to the dissociation of the assemblies and the decrease of the fluorescent intensity of the dye, which was exploited for trypsin detection and inhibitor screening. A detection level down to 0.044 ng mL−1 was obtained for trypsin. Moreover, the emission wavelength and detection range could be tuned by simply varying the type of fluorescent dye.