30 November 2021 in IEEE Access
The energy efficient resource allocation scheme based on genetic algorithm (GA) for the downlink orthogonal frequency division multiple access (OFDMA) heterogeneous networks (HetNets) is developed in this paper. To maximize the spectrum efficiency for the fifth generation (5G) mobile networks, frequency reuse-1 is employed. Thus, advanced inter-cell interference coordination techniques are required to mitigate the inter-cell interference for 5G HetNets. In this paper, the energy efficient optimization problem based on coordinated scheduling is formulated, which is a mixed-integer nonlinear fractional programming problem and is intractable to solve directly. To tackle this, a two-step GA based scheme is proposed to solve the optimization problem. In the first step, the resource blocks matrix is solved by normal GA in the spectral efficiency aspect with fixed power distribution matrix, and then the power distribution matrix is obtained in the second step by non-dominated sorting genetic algorithm II (NSGA-II) with obtained resource blocks allocation matrix. Finally, the system level numerical evaluation process is provided to illustrate the effectiveness of the developed scheme.
22 July 2016 in IEEE Transactions on Communications
By virtue of large antenna arrays, massive MIMO systems have a potential to yield higher spectral and energy efficiency in comparison with the conventional MIMO systems. This paper addresses uplink channel estimation in massive MIMO-OFDM systems with frequency selective channels. We propose an efficient distributed minimum mean square error (MMSE) algorithm that can achieve near optimal channel estimates at low complexity by exploiting the strong spatial correlation among antenna array elements. The proposed method involves solving a reduced dimensional MMSE problem at each antenna followed by a repetitive sharing of information through collaboration among neighboring array elements. To further enhance the channel estimates and/or reduce the number of reserved pilot tones, we propose a data-aided estimation technique that relies on finding a set of most reliable data carriers. Furthermore, we use stochastic geometry to quantify the pilot contamination, and in turn use this information to analyze the effect of pilot contamination on channel MSE. The simulation results validate our analysis and show near optimal performance of the proposed estimation algorithms.
24 March 2021 in IEEE Access
Linear discriminant analysis (LDA) based classifiers tend to falter in many practical settings where the training data size is smaller than, or comparable to, the number of features. As a remedy, different regularized LDA (RLDA) methods have been proposed. These methods may still perform poorly depending on the size and quality of the available training data. In particular, the test data deviation from the training data model, for example, due to noise contamination, can cause severe performance degradation. Moreover, these methods commit further to the Gaussian assumption (upon which LDA is established) to tune their regularization parameters, which may compromise accuracy when dealing with real data. To address these issues, we propose a doubly regularized LDA classifier that we denote as R2LDA. In the proposed R2LDA approach, the RLDA score function is converted into an inner product of two vectors. By substituting the expressions of the regularized estimators of these vectors, we obtain the R2LDA score function that involves two regularization parameters. To set the values of these parameters, we adopt three existing regularization techniques; the constrained perturbation regularization approach (COPRA), the bounded perturbation regularization (BPR) algorithm, and the generalized cross-validation (GCV) method. These methods are used to tune the regularization parameters based on linear estimation models, with the sample covariance matrix's square root being the linear operator. Results obtained from both synthetic and real data demonstrate the consistency and effectiveness of the proposed R2LDA approach, especially in scenarios involving test data contaminated with noise that is not observed during the training phase.
12 August 2017 in Wireless Personal Communications
2 August 2024 in IEEE Access
In many real classification problems where a limited number of training samples is available, the linear classifiers based on discriminant analysis are unable to deliver accurate results. Moreover, the testing and/or the training data can be erroneous due to noise contamination which further degrades their performance. Regularization techniques become imperative to deal with these problems. However, the existing regularization techniques, to some extent, mainly focus on data scarcity issues but completely ignore the noisy nature of the testing and/or the training data. We propose a novel regularized quadratic discriminant analysis (R-QDA) classifier which addresses both issues simultaneously. The procedure involves a reformulation of the discriminant function of the conventional QDA classifier into least square problems and then solving them by using regularized least squares (Reg-LS) based on ℓ 2 -norm. In contrast to existing R-QDA techniques, the proposed R-QDA classifier employs two regularization parameters pertaining to each class, which can be independently selected by various robust techniques. Numerical results demonstrate the effectiveness of the proposed method over classical R-QDA methods, especially in high noise regimes.
15 July 2020 in IEEE Transactions on Information Theory
In [1] , the following line was missing: “Weiyu Xu and Haider Ali Jasim Alshamary contributed equally to this article.”