Jawad Hasan

Jawad Hasan

Auto-generated profile, based on publicly available information

Jawad Hasan

University of Dhaka, Institute of Leather Engineering and Technology

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 June 2022 in Journal of Cleaner Production
Verified
Journal Article
Closed access
JHJawad Hasan
Jawad Hasan
PHPapia Haque
Papia Haque
MRMohammed Mizanur Rahman
Mohammed Mizanur Rahman

18 August 2020 in Textile & Leather Review
Verified
Journal Article
Open access
MUMinhaz Uddin
Minhaz Uddin
JHJawad Hasan
Jawad Hasan
YMYead Mahmud
Yead Mahmud
FTFatema Tuj-Zohra
Fatema Tuj-Zohra
SASobur Ahmed
Sobur Ahmed
Leather manufacturing involves a number of unit processes, out of which tanning is the most important in so far as it converts the putrescible hides/skins into non-putrescible leather. In this study, glutaraldehyde has been exploited as a means to reduce the use of basic chromium sulfate for the production of quality shoe upper crust leather. The paper consists in studying the physical properties of aldehyde-tanned leather and chrome-tanned leather. The aim is to find out the possibility of replacing the wet-blue leather, containing Cr(III) salts, with the glutaraldehyde-tanned wet-white leather. The physical properties of the aldehyde-tanned leather were evaluated, analyzed and compared with the conventional chrome-tanned shoe upper crust leather. Statistical analysis illustrated that the tensile strength, the percentage of elongation, stitch tear strength, Baumann tear strength and grain crack strength of the leather was 211±1 kg/cm2, 38±0.5 %, 89±0.11 kg/cm, 63±0.4 kg/cm and 23±0.4 kg respectively. It was observed that the property of the experimental leather was quite comparable with the conventional chrome-tanned leather and able to meet the requirements of the shoe upper crust leather after re-tanning. The shrinkage temperature of the experimental tanned leather was found to be 87 °C,lower than that of corresponding control, which indicates lesser tanning power of aldehyde. However, the morphology of the aldehyde-tanned leather was quite akin with the conventional leather. This study suggests that using glutaraldehyde in the tanning process in order to minimize the chromium load in the tanning and the re-tanning process during the production of shoe upper crust leather reduces the generation of toxic waste and its impact on the environment.

16 June 2020 in Textile & Leather Review
Verified
Journal Article
Open access
MUMinhaz Uddin
Minhaz Uddin
JHJawad Hasan
Jawad Hasan
DIDidarul Islam
Didarul Islam
ARAshiqur Rahaman
Ashiqur Rahaman
SSSayed Md. Shamsuddin
Sayed Md. Shamsuddin
This study was adopted to investigate the removal of Cr(III)and other physicochemical parameters of chrome tan wastewater. For this purpose, three precipitating agents, CaCO3, NaHCO3, and MgO, were used to treat chrome tan wastewater. After treatment, it was found, in three different dose trials, that each agent removed almost 97-99.5 % of chromium. At the same time, it was observed that with the increase of doses, removal percentage of TDS, conductivity, and turbidity of effluent were reduced. In the case of NaHCO3 and CaCO3, Cr(III) removal percentage at optimum pH was found to be 99.97% and 99.95% respectively, whereas the maximum removal percentage for MgO was found to be 99.98%. The NaHCO3 and CaCO3 were found to be comparable to MgO for Cr(III) removal from chrome tan wastewater. The recovered chromium concentration in the sludge for NaHCO3 and CaCO3 were also similar to that of MgO. This research suggests that these two precipitating agents can be used in the same way as MgO, for Cr removal and recovery treatments. Moreover, this recovered chromium can be reused, thus reducing the environmental pollution.

1 February 2022 in Cleaner Engineering and Technology
Verified
Journal Article
Open access
MUMinhaz Uddin
Minhaz Uddin
JHJawad Hasan
Jawad Hasan
YMYead Mahmud
Yead Mahmud
NUNizam Uddin
Nizam Uddin
KRKhandaker Tanzim Rahman
Khandaker Tanzim Rahman
SSSayed Shamsuddin
Sayed Shamsuddin

23 December 2024 in Biomass Conversion and Biorefinery
Verified
Journal Article
Closed access
PDF file
TUTamish Mobash Shira Urmi
Tamish Mobash Shira Urmi
JHJawad Hasan
Jawad Hasan
MRMahfujur Rahman
Mahfujur Rahman

10 October 2023 in ChemRxiv
Verified
Preprint
Open access
PDF file
ASAbu Jafor Siddiki
Abu Jafor Siddiki
JHJawad Hasan
Jawad Hasan
URUttam Kumar Roy
Uttam Kumar Roy
ASAftab Ali Shaikh
Aftab Ali Shaikh
MHMokarom Hossain
Mokarom Hossain
The biomass utilization without purification and fractionation through a non-selective manner is the best option for high conversion efficiency. Leftover and abundant plant biomass can be a source of preservatives if they keep antimicrobial activity against spoilage microorganisms. Traditionally, 50% w/w sodium chloride (NaCl) is employed for hides and skin preservation (curing). However, enormous water pollution, aquatic toxicity, soil infertility, and high chemical consumption make it questionable. This study investigates biomass-based curing (BBC) agents from Cynodon dactylon grass and Alzibia lebbeck leaves. The plant’s dry powder was directly applied over goatskin and evaluated curing efficiencies. The BBC formulations were user-friendly, highly biomass conversion efficiency (41-53% of raw wt.) and antimicrobial activity (against E. coli: 17-18 mm and B. subtilis: 15-17 mm), and preserved goatskin for 30 days like NaCl. It reduced the salinity and total dissolved solids (TDS) load from tannery-soaking effluent by 67-74% and 41-65%, respectively. The environmental efficiency index (EEI) revealed that BBC systems (EEI: 29.9-31.3) are around 1.5 times more environmentally sustainable than conventional curing (EEI: 20.7). Besides, the alternatives have no effect on the features of final leather. In conclusion, the ecofriendly BBC agents have the potential to minimize the heavy pollution of salt curing.